Plantronics 920 - Manual (Page 7)

0 0
To make a call, simply dial the number via your internet calling application.
To answer or end a call, press the call control button.
When using PerSonoCall, the radio link between the headset and the USB Bluetooth
adapter will only be active during a call. This is the default setting intended to preserve the
battery life of the headset. However, you may wish to have the radio link active when not
on a call so you can listen to other audio sources, such as streaming audio on your PC.
NOTE: Locking the radio link on for extended periods of time will significantly reduce the standby
and talk time of the headset.
For internet calling applications Not Compatible with PerSonoCall
Check the PerSonoCall compatibility list at www.plantronics.com/personocall for the most
current information on internet calling application compatibility.
If your internet calling application is not currently supported by PerSonoCall, remote
detection and answer/end via the headset does not function. Pressing the call control
button on the headset will only open and close the radio link providing audio; you must
answer the call from the internet calling application.
13 12
uSiNg YOur hEAdSET
Answering/Ending/making Calls
with PerSonoCall on an internet calling
application
Tips
If you’re wearing the headset, you hear ascending tones when the power turns on and •
descending tones when the power turns off.
When you receive a call, your phone may ring before your headset rings. Wait until you •
hear the ring in your headset before you press the call control button to answer the
call.
For best performance, position your phone on the same side of your body as your •
headset.
To quickly re-connect to your recently used device that is within range, briefly press •
the call control button.
To cancel an outgoing call, briefly press the call control button. •
iNdiCATOr LighTS
HEadSET iNdiCaTOr ligHTS
action light Tone
Charging Solid red None
Fully charged None None
Low battery Double red flash every 10 seconds 2 high tones every
30 seconds
Pairing Flashes red and blue 1 low tone
Paired Flashes blue 1 low tone
Turning on Solid blue for 2 seconds Ascending tones
Standby Blue flash every 10 seconds None
Missed call Flashes purple every 10 seconds None
Out of range None 1 high tone
Back in range 1 blue flash 1 low tone
Turning off Solid red for 4 seconds Descending tones
TiP: To reset the missed call indicator, press the call control button once.
rANgE
To maintain a connection, keep your headset within 33 feet (10 metres) of the Bluetooth
device. If there are obstacles between your headset and the device you may experience
interference. For optimal performance, place your headset and phone on the same side of
your body.
As you move out of range, audio quality degrades. When you are far enough away to lose the
connection, you hear a high tone in the headset. The headset attempts to reconnect after 30
seconds. If you move back in range later, you can manually reconnect by pressing the call
control button.
NOTE: Audio quality is also dependent upon the device with which the headset is paired.
BluETOOTH uSB adaPTEr iNdiCaTOr ligHTS
action light
Disconnected from the Headset Flashes Purple
Connected to the Headset Solid Blue
Radio Link Active Flashes Blue
Pairing Mode Flashes red and blue