Poulan 810 EP - Manual (Page 11)

11
OPERATION
KNOW YOUR PRUNER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments. Save this manual for future reference.
Cord Retainer
Assist Handle
Recessed
Plug
Trigger Switch
Motor Housing
Shaft
Coupler Pruner
Chain
Bar
Bar oil fill cap
Bar nut
Shoulder Strap Clamp
Attachment Hanger
RECESSED PLUG
The RECESSED PLUG is where you attach
your extension cord to the unit.
TRIGGER SWITCH
The TRIGGER SWITCH is used to turn on the
unit. Squeeze the trigger switch to operate the
unit. Release to stop.
COUPLER
The COUPLER enables optional attach-
ments to be installed on the unit.
CHAIN TENSION
It is normal for a new chain to stretch during
first 15 minutes of operation. You should
check your chain tension frequently. See
CHAIN TENSION in the SERVICE AND AD-
JUSTMENTS section.
OPERATING INSTRUCTIONS
Use only a voltage supply as specified on
your unit.
SELECT AN EXTENSION CORD
Extension Cord Gauge Chart
Length of Cord Gauge
25 Ft. (7.5 m)
50 Ft. (15 m)
100 Ft. (30 m)
18 Gauge
16 Gauge
14 Gauge
Extension cords are available for this unit.
ATTACH THE EXTENSION
CORD TO YOUR PRUNER
Make a loop in your extension cord and attach
the cord as shown. Ensure the plug and cord
are firmly and fully engaged.
Cord Retainer
Extension Cord
Recessed Plug on Unit
BEFORE STARTING PRUNER
Be sure to read the electrical safety informa-
tion in the safety rules section of this manual
before you begin. If you do not understand the
electrical safety information do not attempt to
use your unit. Seek help from someone that
does understand the information or call the
customer assistance help line at
1-800-554-6723.
GUIDE BAR AND CHAIN OIL
The bar and chain require lubrication. The
chain oiler provides continuous lubrication to
the chain and guide bar. Lack of oil will quickly
ruin the bar and chain. Too little oil will cause