Warning, Helpful tip – Poulan 530165213 User Manual

Page 6

-- 6 --

OPERATING POSITION

Blower

Eye

Protection

Vacuum

OPERATING TIPS

While vacuuming or blowing debris, hold

the unit with the muffler side facing away

from your body and clothes (see OPERAT-

ING POSITION illustration above).

To reduce the risk of hearing loss

associated with sound level(s), hearing

protection is required.

To reduce the risk of injury associated with

contacting rotating parts, stop the engine be-

fore installing or removing attachments. Do

not operate without guard(s) in place.

Operate power equipment only at reasonable

hours--not early in the morning or late at night

when people might be disturbed. Comply with

times listed in local ordinances. Usual recom-

mendations are 9:00 a.m. to 5:00 p.m.,

Monday though Saturday.

To reduce noise levels, limit the number of

pieces of equipment used at any one time.

To reduce noise levels, operate power

blowers at the lowest possible throttle

speed to do the job.

Use rakes and brooms to loosen debris be-

fore blowing.

In dusty conditions, slightly dampen sur-

faces or use a mister attachment when wa-

ter is available.

Conserve water by using power blowers

instead of hoses for many lawn and garden

applications, including areas such as gutters,

screens, patios, grills, porches, and gardens.

Watch out for children, pets, open windows,

or freshly washed cars. Blow debris away

safely.

Use the full blower nozzle extension so the

air stream can work close to the ground.

After using blowers and other equipment,

CLEAN UP! Dispose of debris in trash re-

ceptacles.

BEFORE STARTING ENGINE

WARNING:

Be sure to read the fuel

information in the safety rules before you be-

gin. If you do not understand the safety rules,

do not attempt to fuel your unit. Call

1-800-554-6723.

FUELING ENGINE

WARNING:

Remove fuel cap slowly

when refueling.

HELPFUL TIP

To obtain the correct oil mix

ratio, pour 3.2 ounces of

2--cycle synthetic oil into

one gallon of fresh gas.

This engine is certified to operate on

unleaded

gasoline.

Before

operation,

gasoline must be mixed with a good quality

synthetic 2-cycle air-cooled engine oil

designed to be mixed at a ratio of 40:1. Poulan

PROR brand synthetic oil is recommended.

Mix gasoline and oil at a ratio of 40:1. A 40:1

ratio is obtained by mixing 3.2 ounces (95 ml)

of oil with 1 gallon (4 liters) of unleaded

gasoline. DO NOT USE automotive oil or

boat oil. These oils will cause engine damage.

When mixing fuel, follow instructions printed

on container. Once oil is added to gasoline,

shake container momentarily to assure that

the fuel is thoroughly mixed. Always read and

follow the safety rules relating to fuel before

fueling your unit.

IMPORTANT

Experience indicates that alcohol blended

fuels (called gasohol or using ethanol or

methanol) can attract moisture which leads to

separation and formation of acids during

storage. Acidic gas can damage the fuel

system of an engine while in storage. To avoid

engine problems, empty the fuel system

before storage for 30 days or longer. Drain the

gas tank, start the engine and let it run until the

fuel lines and carburetor are empty. Use fresh

fuel next season.

Never use engine or

carburetor cleaner products in the fuel tank or

permanent damage may occur.

NOTE:

Unit must be placed on its side when

adding fuel (see illustration below).

TO STOP THE ENGINE

To stop the engine, move the throttle lever

to the STOP position.

BEFORE STARTING THE ENGINE

WARNING:

You MUST make sure

the tubes are secure before using the unit.

Fuel engine. Move at least 10 feet (3 me-

ters) away from the fueling site.