Porter-Cable PTS2 - Manual (Page 5)

5- ENG D22719
ASSEMBLY
SPECIFICATIONS
OPERATION
Free Speed (No Load) 18,000 RPM
Maximum Working Pressure 90 PSI
Pad Diameter 3”, 4.5”, and 5.5”
Air Inlet 1/4" NPT
Recommended Hose Size 3/8" I.D.
Air Consumption @ 90 PSI 12.5 SCFM
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D.
and fittings should have 1/4” NPT thread.
Operation
Before each use:
l Drain water from air compressor tank
and condensation from air lines. See
air compressor’s operators manual.
Disconnect
the tool from
the air supply before lubricating or
changing sandpaper disc.
l Lubricate tool, see “Maintenance”
section in this manual.
l Select the required sandpaper pad
(A) and sandpaper (B).
l Remove pad nut (C).
l Press pad nut (C) through sandpaper (B) and sandpaper pad (A).
l Holding hub (D) assemble pad nut with sandpaper and sandpaper pad.
l Place holding rod (E) into hole located on hub and tighten securely. NOTE: Holding
rod (E) is used to tighten or loosen hub.
Air Inlet
Pad
Nut
Trigger
Sandpaper
Pad with
Sandpaper
Regulator
Knob
B
A
A,B C
D E