Poulan 191616 User Manual

Page 14

Attachemnt
Lift Lever
High Position

Attachment Clutch Switch
“Engaged” Position

“Disengaged”
Position

Low
Position

Defl ector
Shield

TO TRANSPORT
• Raise attachment lift to highest position

with at tach ment lift control.

• When pushing or towing your trac tor,

be sure gearshift lever is in neutral (N)
position.

• Do not push or tow tractor at more than

fi ve (5) MPH.

NOTE: To protect hood from damage when
transporting your tractor on a truck or a
trailer, be sure hood is closed and secured
to tractor. Use an appropriate means of
tying hood to tractor (rope, cord, etc.).

• The average lawn should be cut to ap-

prox i mate ly 2-1/2 inches during the cool
season and to over 3 inches during hot
months. For healthier and better looking
lawns, mow often and after moderate
growth.

• For best cutting performance, grass over

6 inches in height should be mowed
twice. Make the fi rst cut relatively high;
the second to desired height.

TO OPERATE ON HILLS

WARNING: Do not drive up or down

hills with slopes great er than 15° and do
not drive across any slope. Use the slope
guide provided at the back of this manual.
• Choose the slowest speed before start-

ing up or down hills.

• Avoid stopping or changing speed on hills.
• If slowing is necessary, move throt tle

control lever to slower position.

• If stopping is absolutely necessary, push

clutch/brake pedal quickly to brake posi-
tion and engage parking brake.

• Move gearshift lever to 1st gear. Be

sure you have allowed room for trac tor
to roll slightly as you restart movement.

• To restart movement, slowly re lease

parking brake and clutch/brake ped al.

• Make all turns slowly.

TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt
by the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine. You must
remain fully and centrally positioned in the
seat to prevent the engine from hesitating
or cutting off when operating your equip-
ment on rough, rolling terrain or hills.
1. Select desired height of cut.
2. Start mower blades by engaging at-

tach ment clutch control.

TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted
when they are slightly off the ground when
mower is at the desired cutting height in
operating position. Gauge wheels then
keep the deck in proper position to help
prevent scalping in most terrain conditions.
NOTE: Be sure tractor is on a fl at level
surface.
1. Lower mower and adjust mower to de-

sired cutting height(See “TO AD JUST
MOWER CUT TING HEIGHT” in this
sec tion of manual).

2. Remove retainer spring and clevis pin

which secure each gauge wheel bar.

3. Lower gauge wheels to ground. Raise

gauge wheels slightly to align holes
in bracket and gauge wheel bar and
insert clevis pin. Gauge wheels should
be slightly off the ground.

4. Replace retainer spring into clevis pin.
5. Be sure all gauge wheels are in the

same setting.

IMPORTANT: Be sure to readjust gauge
wheels if you change the cutting height
of the mower deck.

019

Clevis
Pin

Retainer
spring

TO STOP MOWER BLADES -
disengage at tach ment clutch con trol.

CAUTION: Do not operate the mower

without either the en tire grass catcher,
on mowers so equipped, or the defl ector
shield in place.