Philips HP8331 - Manual (Page 4)

2 Straighten your hair
Note: Never put the appliance in the supplied hard case sleeve
when it is heating up or when it is hot.
Connect the plug to a power supply socket. 1
Switch on the appliance ( 2 ).
The power-on indicator ( » ) lights up.
After 60 seconds, the appliance heats up. »
Comb your hair and take a section that is not wider than 5cm 3
for straightening.
Place it between the straightening plates ( 4 ) and press the
handles together.
Slide the straightener down the length of the hair in a single 5
motion (max. 5 seconds) from root to end, without stopping to
prevent overheating.
To create flicks, turn the straightener half-circle inwards (or
•
outwards) when it reaches the hair ends. Hold the straightener
in that position for 2 to 3 seconds, and then release it.
After 20 seconds, repeat step 5 until you achieve the desired 6
look.
To straighten the rest of your hair, repeat steps 3 to 6. 7
After use:
Switch off the appliance and unplug it. 1
Place it on a heat-resistant surface until it cools down. 2
Clean the appliance and straightening plates by damp cloth. 3
Keep it in a safe and dry place, free of dust. You can also hang it 4
with the hanging loop ( ) or store it in the supplied hard case
sleeve ( ).
3 Guarantee and service
If you need information or if you have a problem, please visit the
Philips website at www.philips.com or contact the Philips Customer
Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Consumer Care Centre
in your country, go to your local Philips dealer.