Philips TP2781 - Manual (Page 38)

M
ORE
PIP (P
ICTURE
-I
N
-P
ICTURE
) C
ONNECTIONS
ANT "A"
75
L
AUDIO
R/MONO
IN-2 IN-1 OUT
VIDEO
S-VIDEO
ATTENTION - TO AVOID DAMAGE
1. DO NOT CONNECT SURROUND SOUND SPEAKERS
TO A SEPARATE AMPLIFIER OR TO SPEAKERS
CONNECTED TO ANOTHER PRODUCT.
2. DO NOT CONNECT LEFT AND RIGHT SPEAKER
OUTPUT TOGETHER.
1
ANTENNA
OUT
ANTENNA
IN
VIDEO AUDIO
IN IN
OUT OUT
R L
OR
2
4
3
AC-3(ANALOG OFF)
PCM(ANALOG ON)
AUDIO OUT
AUDIO SELECTION
PCM/
AC-3 DIGITAL
1
2
R L
ANALOG
VIDEO S
VIDEO OUT
P IP hookup with a VCR and a
Digital Video Disc Player (or
similar device).
First connect the original cable
TV signal or Antenna signal to the
ANT IN jack on the back of the
VCR.
Connect the ANT OUT jack on
the rear of the VCR to the ANT “A”
input on the rear of the TV.
Connect the yellow Video Cable
from the VIDEO OUT jack on the
VCR to the VIDEO IN jack on the
TV (labeled VIDEO IN-2). Then,
connect the red and white Audio
Cables from the AUDIO OUT jacks
on the VCR to the AUDIO IN jacks
on the rear of the TV (labeled
AUDIO L & R/MONO IN-2).
Connect the yellow Video Cable
from the VIDEO OUT jack on the
Digital Video Disc Player to the
VIDEO IN jack on the TV (labeled
VIDEO IN-1). Then, connect the red
and white Audio Cables from the
AUDIO OUT jacks on the Digital
Video Disc Player to the AUDIO IN
jacks on the rear of the TV (labeled
AUDIO L & R/MONO IN-2).
Note: When selecting the PIP
SOURCE, the Digital Video Disc
Player will appear on the AV 1
channel, and the VCR will appear
on the AV 2 channel.
BEGIN
REAR OF TV
AUDIO CABLES
(RED AND WHITE)
VIDEO
CABLE
(YELLOW)
VCR DVD (OR SIMILAR)
VIDEO
CABLE
(YELLOW)
OUTSIDE UHF/VHF
ANTENNA OR
CABLE TV SIGNAL
75 OHM
COAXIAL
CABLE
AUDIO CABLES
(RED AND WHITE)
75 OHM
COAXIAL
CABLE