Philips AE2730 - Manual (Page 6)

Basic operation
1 Connect the supplied switching adapter to
the wall outlet and the DC jack on the set
or insert batteries as described in Power
Supply.
• Turn the source selector to TUNER to
select tuner mode.
• Turn the source selector to AUX to select
AUX mode.
➜ The indicator light is lit in the previous
two modes.
• Turn the source selector to OFF to switch
off the set.
➜ The indicator light is off.
2 To adjust volume, turn VOLUME +/–.
Switching on radio
1 Turn the source selector to TUNER.
2 Turn FM/MW selector to FM or MW to
select FM or MW waveband.
Manual tuning
By using this feature, it is possible to manually
tune to a specific channel frequency. In addi-
tion to antenna orienting for better radio
reception, the optimum reception can also be
obtained by using this feature.
1 In FM/MW mode, turn TUNING wheel to
tune to stations.
Helpful hints:
– For FM waveband, a white point over the
tuning wheel indicates the current FM fre-
quency.
– For MW, a white point below the tuning
wheel indicates the current MW frequency.
AUX IN
You can listen to the sound of the connect-
ed external device through your AE2730.
1 Turn source selector to AUX to select AUX
mode.
2 To avoid noise distortion, turn down the vol-
ume on your external device.
3 To adjust the sound and volume, use the
sound controls on your external device and
AE2730.
Basic Operation Radio/AUX
AE2730_12_A_CCR 2008.6.24 10:00 Page 6