Polaroid TTM-2401 - Manual (Page 15)

Use previous channel button
Press button to switch between the current channel and
the previous one.
Notes:
Use DSP button to know the current channel number
Press button to display the
current state of the TV. If the TV is
in program viewing mode, it will
display the current channel
n u m b e r,
s o u n d m o d e a n d
remaining sleep time (if set).
DSP
12 ST SAP
Channel selection
Use Direct Channel Select buttons
Use Channel up/down buttons
You can select desired TV programs by one of the following
methods.
Press
Press CH+ button, the channel number increases;
, the channel number decreases. button CH-
14
CH-
Direct channel
select buttons
CH+
DSP
Sleep 22
?
AIR Mode Direct Channel Selection
When the menu option in menu is in the
position, all channels can be selected by directly entering
the channel number.
Signal Input Search
Air
?
CATV Mode Direct Channel Selection
When the menu option in menu is in the
position, channels can be selected as follows:
Signal Input Search
CATV
Method 1:
Directly enter the channel number and wait for a few
moments.
Method 2:
1-9: Press “0” twice, then 1-9 as needed. For example, to
select channel 2, press “002”.
10-99: Press “0”, then the remaining 2 digits. For example, to
select channel 12, press “012”.
100-125: Press the 3 digits in order. For example, to select
channel 120, press “120”.
TV/AV
CCD
DSP
MUTE
1 2 3
4 5 6
7 8 9
0
SCAN P
CH+
MENU
CH-
V- V+
STEREO
To scan programs
Press button and the TV will scan the channels from the
current channel to higher channels one by one. Every program
will be displayed for about one second and then the TV will
continue scanning.
Press
button again and the TV will stop at the displayed
program.
SCAN
SCAN