beautypg.com

Service and adjustments – Poulan Pro PB20H42YT LAWN TRACTOR User Manual

Page 22

background image

22

SERVICE AND ADJUSTMENTS

FIG. 28

RE TAIN ING
RING

WASH ERS

SQUARE KEY (REAR
WHEEL ONLY)

AXLE COVER

TO START ENGINE WITH A WEAK BATTERY
(See Fig. 29)

WARNING: Lead-acid batteries gen-
er ate ex plo sive gases. Keep sparks,
fl ame and smoking ma te ri als away from
bat ter ies. Always wear eye pro tec tion
when around batteries.

If your battery is too weak to start the engine, it should be
recharged. (See "BATTERY" in the MAINTENANCE sec-
tion of this man u al).
If “jumper ca bles” are used for emer gen cy starting, follow
this pro ce dure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT
SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT
SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START
OTHER VEHICLES.

TO ATTACH JUMPER CABLES -
• Connect one end of the RED cable to the POSITIVE

(+) terminal of each battery(A-B), taking care not to
short against tractor chassis.

• Connect one end of the BLACK ca ble to the NEGA TIVE

(-) terminal (C) of fully charged battery.

• Connect the other end of the BLACK cable (D) to good

chassis ground, away from fuel tank and bat tery.

TO REMOVE CABLES, REVERSE ORDER -
• BLACK cable fi rst from chassis and then from the fully

charged battery.

• RED cable last from both batteries.

FIG. 29

WEAK OR DEAD
BATTERY

FULLY CHARGED
BATTERY

TO REMOVE WHEEL FOR REPAIRS
(See Fig. 28)

• Block up axle securely.
• Remove axle cover, retaining ring and washers to allow

wheel removal (rear wheel contains a square key - Do
not lose).

• Repair tire and reassemble.
• On rear wheels only: align grooves in rear wheel hub

and axle. Insert square key.

• Replace washers and snap retaining ring securely in

axle groove.

• Replace axle cover.
NOTE: To seal tire punctures and prevent fl at tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.

FRONT WHEEL TOE-IN/CAM BER

Your new tractor front wheel toe-in and camber is set at the
factory and is normal. The front wheel toe-in and camber
are not adjustable. If damage has occurred to affect the
factory set front wheel toe-in or camber, contact a qualifi ed
service center.