Philips 1060X - Manual (Page 13)

ENGLISH
Note: Individual shaving heads are not removable
from the Razor Head Assembly.
C
3 Rinse all three shaving heads and three
hair chambers under hot tap water by
letting the water run in and around all the
openings for at least 30 seconds.
BE CAREFUL TO TEST WATER FIRST SO AS
NOT TO BURN OR SCALD HANDS.
C
4 You can also immerse the Razor Head
Assembly in hot water with some liquid
soap or a degreasing liquid (e.g. alcohol)
for at least 30 seconds.
Make sure the razor is ON to thoroughly
remove any residue. Rinse Razor Head Assembly
completely under hot tap water before using
razor.
5 Carefully shake off excess water and leave
the shaving heads open to dry the Razor
Head Assembly completely.
C
6 Press each shaving head back onto the
Razor Head Assembly. You will hear a
‘click’.
7 Allow Razor Head Assembly to completely
air dry before storing.
24 ENGLISH
Razor Head Assembly: With A Brush
1 Turn razor OFF.
C
2 Using your thumb and forefinger pull each
individual shaving head open.
Note: Individual shaving heads are not removable
from the Razor Head Assembly.
C
3 Brush out hairs from each shaving head
and hair chamber with the supplied brush.
C
4 Press each shaving head back onto the
Razor Head Assembly. You will hear a
‘click’.
Trimmer: After Each Use
1 Turn razor OFF.
C
2 Push the trimmer slide switch forward to
slide out the trimmer.
25