Parrot 3200 LS-Color - Manual (Page 4)

4
INTRODUCTION
The Bluetooth® technology enables voice and data communications via a
short-distance radio link. It allows several electronic devices to
communicate with each other, particularly telephones and hands-free kits.
Parrot is drawing on its long years of experience in signal processing and
voice recognition technology to introduce a hands-free kit offering superior
audio quality during calls.
Thank you for buying a Parrot hands-free kit. With the Parrot 3200 LS-Color, you
will be able to make telephone calls from your car while keeping your hands on
the wheel.
With its colour interface and customisable wallpaper, the Parrot 3200 LS-Color
is the most user-friendly hands-free kit. It acts as a real extension of your mobile
phone. We hope that the kit will give you complete satisfaction.
KIT CONTENTS
„ Colour LCD screen
„ Installation cable
„ Electronic control unit
„ Directions for use
„ Fitting accessories
„ Microphone
FITTING
First of all, choose the place for the colour screen inside your vehicle.
We would advise you to fit it in the centre of the dashboard or near you.
Make sure that you can view the screen at a good angle and that it does not obs-
truct your view of the road. Once the hands-free kit is fully installed and switched
on, you can adjust the screen's brightness.
There are two places where you can choose to fit the microphone connection:
either directly at the side of the screen or on the cable connected to the bottom
of the screen. Place the microphone to the left of the rear-view mirror to ensure
optimum audio quality.
The installation cable is equipped with ISO connectors and a line-out jack for
connecting directly to your amplifier, if applicable.
Car stereo with line-in jacks:
Preferably use this type of connection by connecting the brown and white wires
(or red and black), along with the yellow mute wire to the back of your car ste-
reo.
Car stereo with ISO connectors:
Disconnect the car stereo's audio and power leads. Join the female connectors of
the kit's cable to the car stereo. Join the vehicle's audio and power supply cables
to the male connectors. If the car stereo features a mute jack, connect the yellow
wire of the kit's cable to one of the "mute-in" jacks (1, 2 or 3).
Car stereo without ISO connectors:
You must purchase an ISO adapter cable.
Fitting the kit's cable:
. The red wire of the kit's cable must be connected to the constant 12V supply,
the orange wire to the ignition 12V and the black wire to earth.
. Check the wiring diagram of the car stereo's ISO lead.
On some vehicles, the red and orange wires may need to be reversed.
This can easily be done by reversing the two fuse holders.
. Do not connect the orange wire to the constant 12V supply, as you could run
down the vehicle's battery.
Checking the installation:
. If your 3200 LS-Color is correctly fitted, you should see the message
"Goodbye" on the screen when you switch off your car's ignition.
Otherwise, the ignition 12V and the constant 12V supply have been reversed. In
this case, reverse the two fuse holders on the kit's power supply lead.
Notice 3200CL 3400 ZoneC14.12.05.qxp 10/01/2006 17:13 Page 4