Poulan 545212828 - Manual (Page 6)

-- 6 --
INSTALLING ATTACHMENT
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Position locking/release button of attach-
ment into guide recess of upper shaft
coupler.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
Coupler Primary Hole
Upper
Shaft
Locking/
Release
Button
Attachment
Guide Recess
WARNING: Make sure the locking/
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit. Using the wrong hole could
lead to serious injury or damage to the unit.
Locking/Release
Button in Primary Hole
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for storage
when attachment is not in use. To install hang-
er on attachment:
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Press and hold the locking/release but-
ton.
3. Push hanger onto the attachment until
the locking/release button snaps into the
hole.
OPERATING POSITION
Eye Protection
ALWAYS WEAR:
WARNING:
Inspect the area before
using the unit. Remove all debris and hard
objects such as rocks, glass, wire, etc., that
can ricochet, be thrown, or otherwise cause
injury or damage during operation.
Use your blower attachment for:
S
Sweeping debris or grass clippings from
driveways, sidewalks, patios, etc.
S Blowing grass clippings, straw, or leaves into
piles, or removing debris from corners,
around joints, or between bricks.
Control air flow by directing the blower dis-
charge opening down or to one side. Always
work away from solid objects such as walks,
large stones, vehicles, and fences.
Clean corners by starting in corners and moving
outward. This will help prevent an accumulation
of debris which could fly into your face.
Be careful when working near plants. The force
of the air could damage tender plants.
MAINTENANCE
WARNING:
Always stop unit and dis-
connect spark plug wire (or disconnect pow-
erhead from power source) before performing
maintenance.
CHECK FOR LOOSE FASTENERS
AND PARTS
S Housing Screws
INSPECT AND CLEAN UNIT
AND LABELS
S After each use, inspect complete unit for
loose or damaged parts. Clean the unit and
labels using a damp cloth with a mild deter-
gent.
S Wipe off unit with a clean dry cloth.