Pioneer Super Tuner III D AVH-P6550DVD - Manual (Page 74)

Adjusting initialsettings
1
Initial settings lets you perform initial set up of
different settings for this unit.
1 Function display
Shows the function names.
1 Touch the source icon and then touch
SOURCE OFF to turn this unit off.
# When the source icon is not displayed, you
can display it by touching the screen.
2 Touch A.MENU and then touch INITIAL
to display the function names.
The function names are displayed and oper-
able ones are highlighted.
# When A.MENU is not displayed, you can dis-
play it by touching the screen.
# You can also display MENU by clicking the
joystick.
# To go to the next group of function names,
touch NEXT.
# To return to the previous group of function
names, touch PREV.
# When the multi-channel processor (e.g., DEQ-
P7050) is connected to this unit, you can operate
DIGTL ATT instead of REAR SP.
# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Touch A.MENU and INITIAL and then
touch FM STEP.
2 Touch c or d to select the FM tuning
step.
Touching c or d will switch the FM tuning
step between 100 kHz and 50 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
1,602 kHz allowable) to 10 kHz (530 1,640
kHz allowable).
1 Touch A.MENU and INITIAL and then
touch AM STEP.
2 Touch c or d to select the AM tuning
step.
Touching c or d will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
InitialSettings
En
74
Section
16