Philips SE 7450 - Manual (Page 11)

Configure your SE7450 9
3 Configure your
SE7450
3.1 Install battery
Warning
Always use AAA rechargeable batteries
supplied with your unit. There could be
risk of battery leakage if you use alkaline
batteries or other battery types.
Slide out the battery cover.
Place the batteries in the correct
polarity as indicated and replace the
cover.
3.2 Change the Display Language
Your handset can support different display
languages, depending on your country
selection during the WELCOME mode.
Press
m
MENU in idle mode,
scroll
:
to Personal Set and press
m
SELECT , scroll
:
to
Language and press
m
SELECT .
Scroll
:
to your desired language
and press
m
SELECT to confirm.
• A validation tone is emitted and the
screen returns to previous menu.
Tip
Once the display language is set, the
option menus on the handset will switch
to display in the selected language
immediately. However, it will not change
the language of the predefined outgoing
message of your answering machine.
3.3 Registration
The procedures described below are the
procedures that you will find in your
handset. The procedures may vary
according to the handset you want to
register. In this case, please refer to the
manufacturer of the additional handset.
Additional handsets must be registered to
the base unit before you can use them. Up
to 6 handsets can be registered to one
base station.
The Master PIN is required before you
can register or unregister handsets.
Note
By default, the Master PIN is 0000.
3.3.1 Register your SE7450
After charging it for a few minutes, the
word WELCOME appears on a blue
screen. Next, the idle screen appears.
Follow these steps to register your
handset:
In idle mode, the message “Press
Base page key for 3 secs. Press and
1
2
1
2
1
SE7450_IFU_US_English.book Page 9 Monday, May 14, 2007 6:33 PM