Pioneer Elite VSX-90TXV - Manual (Page 51)

Other connections 08
51
En
Surround Back System MULTI-ZONE setup
You must select ZONE2 in Surround back speaker setting
on page 35 to use this setup. Note that the sound in the
sub zone will be temporarily interrupted when controlling
the main zone (for example, changing the input source or
starting playback).
• Connect a TV monitor to the MULTI-ZONE &
SOURCE MONITOR OUT jacks on the rear of this
receiver.
You should have a pair of speakers attached to the
surround back speaker terminals as shown below.
Using the MULTI-ZONE controls
The following steps use the front panel controls to adjust
the sub zone volume and select sources. See
MULTI-
ZONE remote controls below when using the remote
control.
1 Press the MULTI ZONE ON/OFF button on the front
panel.
The
MULTI-ZONE indicator lights and ZONE2 ON
appears in the front panel display to indicate the MULTI-
ZONE control has been switched on.
2 Press CONTROL.
Make sure that any operations for the sub room are done
while
MULTI-ZONE shows in the display. If MULTI-ZONE
is not showing, the front panel controls affect the main
zone only.
3 Use the MULTI JOG dial to select the source for the
room you have selected.
For example,
CD sends the source connected to the CD
inputs to the sub zone.
• If you select TUNER, you can use the front panel
TUNER controls to select a preset station (see Saving
station presets on page 33 if you’re unsure how to do
this). 1
• XM and SIRIUS Radio can be selected only in the
main zone, and when using the MULTI-ZONE feature,
you can’t use the iPod, XM and SIRIUS Radio
functions simultaneously.
4 Use the MASTER VOLUME dial to adjust the
volume.
This is only possible if you selected the
VARIABLE
volume control in Multi Zone Setup on page 58.
2
5 When you’re finished, press CONTROL again to
return to the main room controls.
You can also press the
MULTI ZONE ON/OFF button on
the front panel to switch off all output to the sub zone.
3
MULTI-ZONE remote controls
The following table shows the possible MULTI-ZONE
remote controls:
SPEAKERS
AC OUTLET
A B R L R L R L ( Single)
(Single)
FRONT CENTER SURROUND SURROUND BACK /
SELECTABLE SEE INSTRUCTION MANUAL
IN IN OUT
IN IN MONITOR
OUT OUT
VCR1 DVR/VCR2
AM LOOP
PR
PR
PRE OUT
OUT
IN
3
R
R R R
R R
L L
L L L
L CENTER
CENTER
MULTI CH IN
FRONT
FRONT
SUR-
ROUND
SUR-
ROUND SURROUND BACK
SURROUND
BACK SUB
WOOFER
SUB
WOOFER SWITCHED 100 W(0.8 A) MAX
IN
MONITOR
OUT
12V
TRIGGER
(DC OUT 12V/
50mA MAX) ZONE 2 MULTI-ZONE & SOURCE
SIRIUS
R L
Sub zone Main zone
NITOR
T
R R R
L L L CENTER
MONITOR
OUT
(DC OUT 12V/
50mA MAX)
ZONE 2
MULTI-ZONE
& SOURCE
R L
B
R L ( Single)
SURROUND BACK /
SELECTABLE
SEE INSTRUCTION MANUAL
MULTI JOG MASTER
VOLUME ENTER
VSX-90TXV
STANDBY/ON
PHONES
DVD/LD
PHASE CONTROL
TV / SAT DVR/VCR 1 DVR/VCR 2 VIDEO/GAME CD CD-R / TAPE / MD FM/AM LISTENING MODE
SYSTEM SETUP TUNING/
STATION TUNER EDIT SPEAKERS RETURN TONE
MULTI JOG
MULTI CH IN SB ch PROCESSING SIGNAL
SELECT SIRIUS XM iPod
MCACC SETUP MIC DIGITAL IN AUDIO R L VIDEO VIDEO/GAME INPUT S - VIDEO
ON/OFF MULTI ZONE CONTROL
Note
1 The tuner cannot be tuned to more than one station at a time. Therefore, changing the station in one zone also changes the station in the other zone.
Please be careful not to change stations when recording a radio broadcast.
2 The volume levels of the main and sub zone are independent.
3 • You won’t be able to switch the main zone off completely unless you’ve switched off the MULTI-ZONE control first.
• If you don’t plan to use the MULTI-ZONE feature for a while, turn off the power in both the main and sub zone so that this receiver is in standby.
Button What it does
SHIFT+
RECEIVER Selects the sub zone.
 Switches power on/off in the sub zone.
INPUT
SELECT Use to select the input source in the sub zone.
Input
source
buttons Use to select the input source directly (this may
not work for some functions) in the sub zone.
VOL +/– Use to set the listening volume in the sub zone.
VSX-90TXV_KU.book Page 51 Friday, March 16, 2007 5:46 PM