Philips AZ102N - Manual (Page 7)

Tuner CD Player
General operation
Switching on and off and selecting the
function
1 To select your sound source, adjust the
Source selector to: CD, FM or MW.
2 To switch off the set, adjust the Source
selector to OFF position.
3 To switch to LINE IN mode, connect an
external audio source to the LINE-IN inlet.
Helpful hints:
• The set switches to LINE IN mode
automatically when an external audio source
is connected, no matter the set is in CD, FM
or MW mode.
• The LINE-IN inlet is not for earphones.
Adjusting volume and sound
Adjust the sound with the VOLUME and
DBB controls.
Radio reception
1 Adjust the Source selector to FM or
MW.
2 Turn TUNING to tune to a station.
Helpful hints:
To improve radio reception
• For FM, extend, incline and turn the
telescopic antenna for best reception. Reduce
its length if the signal is too strong.
• For MW, the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
Playing a CD
• This CD player plays Audio Discs including
CD-Recordables (CD-R) and CD-Rewritables
(CD-RW).
• MP3, CD-ROM, CD-I, CDV,VCD, DVD or
computer CDs are not possible for playback.
IMPORTANT!
CDs encoded with copyright protection
technologies by some record companies may
be unplayable by this product.
1 Adjust the Source selector to CD.
2 Open the CD door, and insert a CD with
the printed side facing up, then press the
CD door gently to close.
➜ Display shows --, and later the total
number of tracks. (See 3)
3 Press 2; to start playback.
4 To pause playback, press 2;.
➜ Display: 2 flashes. (See 4)
5 To resume, press 2; again.
6 To stop CD playback, press
9.
Helpful hints:
CD play will also stop when:
– you open the CD door;
– you select FM, MW or OFF sound source;
– the CD has reached the end.
AZ102_12_UM_EN 4/12/10 17:13 Page 7