Preh TOUCH COMMANDER MC15T5 - Manual (Page 13)

13 subject to change without prior notice 05.2004
Preh KeyTec GmbH, www.preh-keytec.com
- FACTORY RESET
Press the + button to restore Volume, OSD V-Position, OSD H-Position, V-Position, H-
Position, Phase, Brightness, Clock to factory default.
- No
+ Yes
Factory Reset
3.4 Mechanical Adjustment of the LCD Position
The LCD position on a VESA Mount Preh Touch / Screen Commander cannot be changed
directly at the Product. The adjustment (tilting or swinging) of the Touch Screen
Commander depends on the pole or wall mount hardware used.
The LCD of the Preh Touch / Screen Commander is swingable and tillable. According to
the usage the LCD position can be changed.
The below picture shows the model with the multimedia base.
Pict. 8: adjusting screws on rear side
The infinitely variable adjustment of the tilting force can be made with two adjusting screws
located on the rear of the monitor. The adjustment torque (1 - 8 Nm) should be about the
same on both screws.
Pict. 9: adjusting screws below
The infinitely variable adjustment of the swinging force can be made with two adjusting
screws in the base of the monitor. The adjustment torque (1 - 8 Nm) should be about the
same on both screws.