Panasonic BB-GT1500C - Manual (Page 70)

Intercom Features
70 For product assistance, visit www.globarange.com
For A assistance, visit www.joip.com
3 When you finish talking, press
{
INTERCOM}.
Note:
L
You can locate a misplaced handset
by paging it.
Answering an intercom call
1 Press {TALK} to answer the page.
2 When you finish talking, press
{
OFF}.
1 Press {INTERCOM} to answer the
page.
2 When you finish talking, press
{
INTERCOM}.
Note for handset and base unit:
L
The ringer volume for intercom calls
follows the higher volume level of the
2 lines (page 52, 56).
L
When the ringer volume is set to off for
both lines, the handset or base unit
rings at a low level for intercom calls.
Answering an intercom call using
auto intercom
Before using the auto intercom, turn auto
intercom on (page 68).
1 When you are paged by the base
unit, speak into the microphone.
L
To switch to the receiver, press
{s}
.
2 To end the intercom, press {OFF}.
Monitoring audio in a room using
auto intercom
You can listen to the sound in a room
where the handset is located using the
auto intercom (page 68).
Important:
L
Before using this feature, set auto
intercom on the destination handset to
“On (Ringer Off)” to allow access
by the base unit (page 68).
1 Call the destination handset (page
69).
L
You can listen to the audio.
2 To mute your sound output, press
{
MUTE} if necessary.
3 Press {INTERCOM} to stop
monitoring.
Handset
Base unit
Handset
Base unit
GT15xxC.book Page 70 Tuesday, July 24, 2007 7:17 PM