Peg-Perego IGED1091 - Manual (Page 7)

the axle into one of the two rear wheels: make
sure you use the wheel shown in Figure A.
10 • Insert the axle with the wheel into the hole of
the gearmotor, pressing to be sure it exits from
the opposite side of the vehicle.
11 • Turn the wheel slightly to match up the
gearmotor pentagon with the one on the
wheel (Figure shows incorrect fastening of the
wheel).
12 • Insert the bushing as shown in the figure,
working from the other side of the shaft until it
is hooked to the body.
13 • Insert an iron washer as shown in the figure.
14 • Reposition the tool (used previously to insert
the self-locking washer - see Figure 7) on the
axle from the wheel side. Place the vehicle on
one side, keeping the wheel underneath. Make
sure the tool cannot shift.
15 • (1)Position the remaining wheel end insert an
iron washer. (2)Insert a self-locking washer on
the provided tool (shown in the figure).
Caution: The tabs of the self-locking washer
must face the inside of the tool (see small
picture A). (3)Fasten the wheel as shown in the
figure, pushing the self-locking washer down
completely.
16 • Snap on the remaining stud covers on both
sides.
17 • Position the handle support.
18 • Slide on the handle, orienting it as shown in the
figure.
19 • Fasten the handle with a washer and screw.
20 • Position the cap by inserting the tongue (1)
into the rear notch of the support. Turn the cap
(2).
21 • Apply the silver decal.
22 • Apply the glass on the front light till it clicks.
23 • Place the trunk support on the vehicle, and
fasten it with the 4 screws that come with it.
24 • Place the trunk on the support, fitting it into
the special hooks, as shown in the figure. Pull
the trunk all the way towards you, to fit it into
place (detail A).
25 • Rotate the red catch behind the saddle until
bringing it to the position shown on figure. A:
the saddle is locked. B: the saddle can be lifted.
Lift up the saddle.
26 • Connect the two plugs.
27 • Reposition the saddle by sliding the two pins
into the holes on the tank. Turn the red catch
behind the saddle in order to fasten it. The
vehicle is ready to use.
VEHICLE FEATURES AND INSTRUCTIONS FOR
USE
28 • GEARSHIFT LEVER: Your child will have fun
pretending to change gears using this gearshift
lever, which can be rotated into two positions.
29 • ACCELERATOR/ELECTRIC BRAKE PEDAL: The
vehicle brakes automatically when your child
lift his/her foot off the pedal.
REPLACING THE BATTERY
30 • Rotate the red catch behind the saddle until
bringing it to the position shown on figure 25
(figure B). Lift up the saddle. Unplug the
terminals. Unscrew the battery fastener.
31 • Lower the catch (1) and, at the same time, push
the battery fastener as indicated by the arrow
(2) to release it. Remove the battery fastener.
32 • Replace the battery. (NOTE: The replacement
battery – separately available – is a 6v/ 8Ah
battery pack). Replace and screw back on the
battery fastener. Connect the two plugs.
CAUTION: When you have finished, remember
to close and fix down the seat.
BATTERY RECHARGE
WARNING: BATTERY CHARGING AND EVERY OTHER
OPERATION ON THE ELECTRICAL SYSTEM MUST BE
CARRIED OUT BY ADULTS ONLY.
THE BATTERY CAN ALSO BE CHARGED WITHOUT
REMOVING IT FROM THE TOY.
33 • Unplug vehicle wiring terminal A from battery
terminal B, by pressing terminals on side and
pulling apart.
34 • Plug the battery charger terminal to a wall
outlet following the instructions enclosed.
Connect the plug B to the battery charger plug
C.
35 • Once the charge is completed unplug
recharger from wall outlet. Unplug recharger
cord terminal C from battery terminal B.
36 • Plug battery terminal A into vehicle wiring
terminal B. Close saddle.
Before riding, charge your batteries for 18 hours to
• PEG PEREGO® thanks you for choosing this
product. For over 50 years, PEG PEREGO has been
taking children for an outing: first with its famous
baby carriages and strollers, later with its pedal and
battery operated toy vehicles.
• Read this instruction manual carefully to learn the
use of this vehicle and to teach your child safe and
enjoyable driving. Please keep this manual for use
as a reference in the future.
• Our toys conform with the safety requirements
provided by the Council of the EEC, of the T.Ü.V.; of
the I.I.S.G. Istituto Italiano Sicurezza Giocattoli, and
the U.S. Consumer Toy Safety Specification F963.
Peg Perego S.p.A. is an ISO 9001
certified company.
The fact that we are certified provides
a guarantee of our honesty for our
customers, and fosters trust in the
company’s way of working.
• Peg Perego reserves the right to modify or change
their product. Price, literature, manufacturing
processes or locations or any combination of these
above mentioned entities may change at any time
for any reason without notice with impunity.
Years 2-4
PEG PEREGO offers after-sales services, directly or
with a network of authorized service centers for
repairs or replacement parts. See the back cover of
this instruction manual for a list of service centers.
Peg Perego is at the consumer's service, meeting
every need in the best way possible. This is why our
customers' opinions are so important and valuable
to us. We would be very grateful if you would kindly
fill in the CUSTOMER SATISFACTION
QUESTIONNAIRE after using one of our products.
You will find the questionnaire on the Internet at
"www.pegperego.com/SSCo.html.en-UK".
Please note any observations or suggestions you
may have on the questionnaire.
ADULT ASSEMBLY REQUIRED.
USE CARE WHEN UNPACKING AS COMPONENTS TO
BE ASSEMBLED MAY POSE A SMALL PARTS/SHARP
EDGE HAZARD.
BATTERY ALREADY INSTALLED IN VEHICLE.
ASSEMBLY
1 • Check the forecarriage to be sure it is correctly
fastened at points (A). Remove the protective
caps (B).
2 • Insert an iron washer on the pin of the
forecarriage, as shown in the figure.
3 • (1)Insert one of the two front wheels: make
sure you use the wheel shown in Figure A.
(2)Insert an iron washer.
4 • Insert a self-locking washer on the provided
tool (shown in the figure). Caution: The tabs of
the self-locking washer must face the inside of
the tool (see small picture A). NOTE: the bag
contains 8 self-locking washers. Keep 4 of them
apart as spare washers.
5 • Fasten the wheel as shown in the figure,
pushing the self-locking washer down
completely.
6 • Snap on the stud cover. Perform the same
operations as the ones in Figure 2 for the other
front wheel.
7 • Insert a self-locking washer on the provided
tool (shown in the figure). Caution: The tabs of
the self-locking washer must face the inside of
the tool (see small picture A).
8 • Remove the grey protective caps at the ends of
the rear axle. Insert the axle on the tool as
shown in the figure.
9 • (1)Insert an iron washer on the axle. (2)Insert
ENGLISH
CUSTOMER SERVICE
ASSEMBLY INSTRUCTIONS
dell’impianto elettrico.
• Non lasciare le batterie o il veicolo vicino a fonti di
calore come caloriferi, caminetti, etc.
• Proteggere il veicolo da acqua, pioggia, neve etc.;
usarlo su sabbia o fango potrebbe causare danni
a pulsanti, motori e riduttori.
• Se il veicolo agisce in condizioni di sovraccarico,
come su sabbia soffice, fango o terreni molto
sconnessi, l’interruttore di sovraccarico toglierà
immediatamente potenza. L’erogazione di
potenza riprenderà dopo alcuni secondi.
• Lubrificare periodicamente (con olio leggero)
parti semovibili come cuscinetti, sterzo etc.
• Le superfici del veicolo possono essere pulite con
un panno umido e, se necessario, con prodotti di
uso domestico non abrasivi.
• Le operazioni di pulizia devono essere effettuate
solo da adulti.
• Non smontare mai i meccanismi del veicolo o i
motori, se non autorizzati dalla PEG PEREGO.
Conforme a EN 50088
Batteria ricaricabile da 6V 4,5Ah al piombo sigillata.
1 motore da 60 W
SICUREZZA
ATTENZIONE! LA SUPERVISIONE DI UN ADULTO É
SEMPRE NECESSARIA.
• Non adatto ai bambini di età inferiore ai 24 mesi
per caratteristiche funzionali.
• Non usare il veicolo su strade pubbliche, dove c’è
traffico e macchine parcheggiate, su pendenze
ripide, vicino a gradini e scale, corsi d’acqua e
piscine.
• I bambini devono sempre indossare scarpe
durante l’uso del veicolo.
• Quando il veicolo è operativo fare attenzione
affinché i bambini non mettano mani, piedi o altre
parti del corpo, indumenti o altre cose, vicino alle
parti in movimento.
• Non bagnare mai componenti del veicolo come
motori, impianti, pulsanti, etc.
• Vicino al veicolo non usare benzine o altre
sostanze infiammabili.
• Il veicolo deve essere usato esclusivamente da un
solo bambino.
DIVERTIMENTO SENZA INTERRUZIONI: tenete
sempre un set-batterie carico di ricambio pronto
all’uso.
Per la sicurezza del bambino: prima di azionare il
veicolo, leggere e seguire attentamente le seguenti
istruzioni.
• ATTENZIONE:
Controllare che tutte le borchie di fissaggio delle
ruote siano ben salde.
• MARCIA AVANTI:
Con entrambe le mani sul manubrio premere il
pedale dell’ acceleratore;
il veicolo si mette in moto ad una velocità di circa
4 Km/h.
• FRENO:
Per frenare alzare il piede dal pedale acceleratore,
il freno entrerà in funzione automaticamente.
Insegnate al vostro bambino un uso corretto del
veicolo per una guida sicura e divertente.
• Prima di partire assicurarsi che il percorso sia
sgombro da persone o cose.
• Guidare con le mani sul manubrio e guardare
sempre la strada.
• Frenare per tempo per evitare scontri.
• ATTENZIONE! se il veicolo agisce in condizioni
di sovraccarico, come su sabbia soffice, fango o
terreni molto sconnessi, l’interruttore di
sovraccarico toglierà immediatamente
potenza. L’erogazione di potenza riprenderà
dopo alcuni secondi.
IL VEICOLO NON FUNZIONA?
• Verificare che non ci siano cavi scollegati sotto la
piastra dell’ acceleratore.
• Controllare il funzionamento del pulsante
dell’acceleratore ed eventualmente sostituirlo.
• Controllare che la batteria sia attaccata all’
impianto elettrico.
IL VEICOLO NON HA POTENZA?
• Caricare le batterie. Se dopo la ricarica il problema
persiste far controllare le batterie ed il
REGOLE PER UNA GUIDA SICURA
PROBLEMI?
BATTERY MAINTENANCE AND SAFETY
caricabatterie da un centro assistenza.