Philips AX3301 - Manual (Page 2)

Handling instructions
• Recharging already charged or half-charged batteries will shorten their
lifetime. We therefore recommend that you let the rechargeable ECO-PLUS
NiMH battery run till it is completely empty before you recharge it.
• To avoid a short circuit, do not let the battery touch any metal object.
• If the battery becomes empty soon after recharging, then either its contacts
are dirty or it has reached the end of its lifetime.
Mains adapter (supplied or optionally available)
Use only the AY 3170 adapter (4.5 V / 300 mA direct
current, positive pole to the center pin). Any other product
may damage the player.
1 Make sure the local voltage corresponds to the power
adapter’s voltage.
2 Connect the power adapter to the 4.5V DC socket of
the player and to the wall socket.
Note: Always disconnect the adapter when you are not using it.
Environmental information
• All redundant packing material has been omitted. We have done our utmost to
make the packaging easily separable into two mono materials: cardboard (box)
and polyethylene (bags, protective foam sheet).
• Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packing materials, exhausted batteries and old equipment.
English CONTROLS / POWER SUPPLY
Controls ( see figure 1 )
1 LINE OUT/p........3.5 mm headphone socket, socket to connect the player to
another audio input of an additional appliance
2 ∞ .......................skips and searches CD tracks backwards
3 9.........................stops CD play, clears a program or switches the player off
4 § .......................skips and searches CD tracks forwards
5 2; ......................switches the player on, starts or pauses CD play
6 PROG...................programs tracks and reviews the program
7 MODE .................selects the different playing possibilities: shuffle,
shuffle repeat all, repeat, repeat all and SCAN
8 ............................display
9 DBB.....................switches the bass enhancement on and off. This button also
switches acoustic feedback (the beep) on/off when it is
pressed for more than 2 seconds
0 VOL − −//+ + ..............adjusts the volume
! 4.5V DC...............socket for external power supply
@ OPEN
2 ..............opens the CD lid
# ESP ON /
POWER SAVE .......to select between the battery powersave mode and
Electronic Skip Protection (ESP). ESP ensures continuous
CD playback regardless of vibrations and shocks
$ OFF......................switches RESUME and HOLD off
RESUME .............stores the last position of a CD track played
HOLD...................locks all buttons
% ............................typeplate
^ ............................battery compartment
& ............................AAA battery door
This set complies with the radio interference requirements of the
European Union.
POWER SUPPLY / GENERAL INFORMATION
Average playing time of batteries under normal conditions
Battery type
ESP on Power Save
Alkaline AA 15 hours 20 hours
Alkaline AAA 7 hours 9 hours
Rechargeable ECO-PLUS NiMH battery 3 hours 5 hours
Batteries contain chemical substances, so they should be disposed
of properly.
ECO-PLUS NiMH battery information (for versions supplied with the
rechargeable ECO-PLUS NiMH battery AY 3363)
Recharging works only on players supplied with the rechargeable ECO-PLUS
NiMH battery AY 3363.
Recharging the ECO-PLUS NiMH battery on board
1 Insert the rechargeable ECO-PLUS NiMH battery AY 3363.
2 Connect the mains adapter to the 4.5V DC socket of
the player and then to the wall socket.
y
is pulsing.
• Recharging stops after a maximum of 7 hours, or
when you start playback.
3 When the battery is fully recharged, FULL appears
in the display.
Notes: – It is normal for the batteries to become warm
during recharging.
– If the batteries become too warm, recharging will be interrupted for
approximately 30 minutes .
– To ensure proper recharging on board, take care that contacts are clean.
– Use only the ECO-PLUS NiMH battery AY 3363.
Batteries (supplied or optionally available)
For convenience, this model is designed with 2 different detachable battery
doors. This allows you to operate the player using 2 choices of battery size.
You can use the following batteries with this CD-player:
• alkaline batteries type AAA (LR03, UM4) or AA (LR6, UM3) preferably
Philips.
Notes:– Old and new or different types of batteries should not be combined.
– Remove batteries if they are empty or if the player is not going to be used for
a long time.
Inserting AAA (LR03, UM4) or AY 3363 batteries
1 Open the AAA battery door.
2 Insert AAA batteries as shown onto the back of the
door.
3 Replace the battery-loaded AAA door back onto the
set.
Inserting AA (LR6, UM3) batteries
To double playback time, insert AA batteries into the
battery compartment and use the AA marked battery
door.
• Open the battery compartment and insert either 2
normal or alkaline batteries.
Battery indication
The approximate power level of your batteries is shown in the display.
Battery full
Battery two-thirds full
Battery one-third full
Battery dead or empty. When the batteries are
dead or empty, the symbol flashes, bAtt is
displayed, and the beep tone sounds repeatedly.
- +
- +
AA SIZE
LR6 / UM3
4.5V DC
-
+
+
LR03/AAA
/UM4
AAA (LR03, UM4)
AA (LR6, UM3)