Porter-Cable 6605 - Manual (Page 9)

9
ASSEMBLY
This tool is shipped completely assembled. No assembly time or tools are
required.
OPERATION
HOW TO HOLD THE SHEAR
T h e g e a r h o u s i n g ,
intermediate plate, and cutting head
may become live if the tool cuts into
wiring. To prevent accidental shock,
hold the tool as shown in Fig. 1.
Fig. 1
TO START AND STOP THE SHEAR
Make sure that the power circuit
voltage is the same as that shown on
the specification plate of the drill and
that the switch is in the “OFF” position.
Confirm that your hands, body, and
clothing are clear of cutting head before
connecting the tool to the power circuit.
Squeeze the trigger switch (A) Fig. 2 to
start the motor. Release the trigger to
stop the motor.
Fig. 2
A
To lock the trigger switch “ON”, squeeze the trigger as far as it will go, push in
the lock button (B) and release the trigger. To unlock the lock button, squeeze the
trigger and release, leaving the lock button free to spring out.
NOTE: The lock button can be engaged only when the drill is running at
maximum speed.
Never use the lock button when a sudden stop may be
possible.
Variable speed – As the trigger switch is squeezed, the speed increases.
B