ProForm 831.29606.0 - Manual (Page 5)

ASSEMBLY
Make sure that the power cord is unplugged. Assembly requires two persons. Set the treadmill in a cleared
area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note:
The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small
amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal con-
dition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the
lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver ,
wire cutters , and adjustable wrench .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST on pages 26 and 27. The number after the parentheses shows
the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of
the parts to be assembled.
If a part is missing, call toll-free 1-888-533-1333.
1. With the help of a second person, raise the Uprights (97)
to a vertical position.
Insert the tab on one of the Handrail Brackets (81) into
the indicated slot in the left Upright (97). Attach the
Handrail Bracket with a 3/4” Tek Screw (52).
Identify the Left Handrail Cover (27), which has holes in
the sides. Slide the Left Handrail Cover onto the upper
end of one of the Handrails (43). Slide one of the
Handrail Caps (105) onto the lower end of the Handrail.
Make sure that the small hole in the Handrail Cap is to-
ward the bend in the Handrail.
97
Slot
Hole
Small Hole
Bend
1
52
105
43
81
27
Nut (20)–4
Base Pad Screw (40)–4
Wheel Bolt (90)–2 3” Bolt (86)–2
Screw (95)–2 3/4” Tek Screw (52)–2
Washer (71)–4
1 3/4” Bolt (76)–2
Cover Screw (34)–4
Handrail Bolt (80)–4
5