La Crosse Technology WS- 1912 - Manual (Page 7)

13
* When the signal from the transmitter/ or rain sensor (optional) is successfully received by
the Weather Station, this icon will be switched on. (If not successful, the icon will not be
shown on the LCD). User can therefore easily see whether the last reception was
successful (“ON” icon) or not (“OFF” icon). On the other hand, the short blinking of the icon
shows that a reception is being done at that time.
** In normal display mode, user may press the SET key shortly to toggle between Mode1
and Mode 2 display:
Mode 1: Wind speed, outdoor temperature, relative air pressure are shown.
Wind speed icon
Outdoor temp
icon
Rel. Air Pressure icon
In Mode 1, this reception icon is showing the condition of the
reception of the signal from Thermo-hygro transmitter
14
Mode 2: Wind gust, dew point, and rainfall (optional) reading are shown.
Note: To view the rainfall data, press the + key after entering Mode 2 display.
MANUAL SETTINGS:
The following manual settings can be changed once the SET key is pressed and held for
about 3 seconds:
 LCD contrast setting
 Manual time setting
 12/24 hour time display
 Calendar setting
 °C/ °F temperature unit setting
 Wind speed unit
 Rainfall unit setting
 Air pressure unit setting
 Relative pressure reference value setting
 Weather tendency threshold value
 Storm warning threshold value
Wind gust icon
Dew point icon
In Mode 2, this reception icon
is showing the condition of the
reception of the signal from
Rain sensor (only if a rain
sensor is being used).
Note: if no rain sensor is used,
the reception icon will always
be displayed in Mode 2.
Rain icon