Lucent Technologies PC Octel 100 User Manual
Voice boards, Fax boards, Network interface card
101-1773-001
O
CTOBER
1999, I
SSUE
1
1
PC Specification Sheet
Octel 100 Version 3.2
This note provides information on the boards installed in the messaging system PC. You will need this information
when connecting the messaging system PC and when running the Configure utility.
There are two back panel diagrams provided later in this note. These diagrams provide the slot configurations for
the Desktop and Tower PC platforms.
Voice Boards
Use the following information when connecting the voice boards to the switch and when running the Configure
utility. Refer to the topic, “Configuring the Voice Boards,” in Chapter 5, “Preparing the Hardware,” in the
Installation
and Service Manual for board diagrams and default board settings.
Number of Voice Boards Installed:
Type of Voice Board Installed:
c
Dialog/4
c
D42DSL
c
D42DSX
c
D42DNS
Fax Boards
Use the following information when connecting the TruFax fax boards to the switch and when running the Configure
utility. Refer to the topic, “Configuring the Fax Boards,” in Chapter 5, “Preparing the Hardware,” in the
Installation
and Service Manual for board diagrams and default board settings.
Number of Fax Boards Installed:
Type of Fax Board Installed:
TruFax
Network Interface Card
A Network Interface Card (NIC) is also installed in the PC. The NIC is preconfigured for use with the messaging
system. If you are using Visual Mailbox, you will need to connect the NIC. See Chapter 19,
c
Network Interface Card