Life Fitness M051-00K63-A032 User Manual

How to:… install the external power kit, Life fitness upright exercise bikes

M051-00K63-A032

Life Fitness Upright Exercise Bikes

How To:… INSTALL THE EXTERNAL POWER KIT

Tools Required: 5/16 Nut Driver, T-20 Torx Driver, T-30 Torx Driver, Wire Cutters

1. Remove the screw securing the RIGHT and LEFT SEAT POST

SHROUDS (A & B) together. Remove the SEAT POST SHROUDS and
set them aside.

2. Remove the three screws securing the USER RIGHT CRANK ARM

AND PEDAL ASSEMBLY (C) to the crank arm mounting plate. Set the
USER RIGHT CRANK ARM AND PEDAL ASSEMBLY aside. Repeat
the procedure for the USER LEFT CRANK ARM AND PEDAL
ASSEMBLY (D).

3. Remove the 10 screws securing the RIGHT and LEFT MAIN

SHROUDS (E & F) together. Remove the user RIGHT and LEFT MAIN
SHROUDS from the FRAME (J).

4. Remove the HOLE PLUG (G) from the lower front of the USER LEFT

MAIN SHROUD (E).

5. Using two supplied screws, attach the BRACKET ASSEMBLY (H) to the

front and user left side of the FRAME (J).

NOTE: THE CABLE (K) SHOULD BE ROUTED TOWARD THE

BOTTOM OF THE UNIT.

6. Route the CABLE (K) under the FRAME (J), around the user right side

of the bike, and to the CONTROLLER BOARD (L) located on the front,
user right side of the FRAME. Plug the 2-PIN (2P) connector into the
available 2-PIN JACK on the CONTROLLER BOARD.

7. Secure the CABLE (K) to the FRAME (J) bottom using a supplied WIRE

TIE. Trim the excess wire tie.

8. Reverse Steps 1-3 to return all SHROUDS and CRANK ARM

ASSEMBLIES to their proper locations.

9. Place the POWER REQUIREMENT STICKER (M) next to the POWER

PLUG ACCESS HOLE (N) in the USER LEFT SHROUD (E).

10. Plug the EXTERNAL POWER CONNECTOR (R) into the BARREL

CONNECTOR.

11. For units sold in the United States, plug the wall-mount transformer into

an electrical outlet (120 VAC).

For units sold elsewhere, plug the appropriate line cord into the
transformer. Then, plug the line cord into an electrical outlet (220-240
VAC).