Life Fitness PCST-INTHX-02 - Manual (Page 23)

23
PLATINUM CLUB SERIES TREADMILL PCST-XXXXX-02
Cables S/N PST100000 and up
AK26-00348-0000 – Qty. 2 – Green and yellow ground wire with spade lug on one
end and ring terminal on the other. One goes from
the IEC connector to the frame and the other from
the line filter to the frame.
AK32-00160-0000 - Qty. 1 – External Power cable with ferrite.
AK65-00062-0000 – Qty. 1 – RG6 Coax cable 75”
AK58-00034-0001 – Qty. 1 – Main Power cable from DSP to Console
AK58-00224-0001 – Qty. 1 – Mov Filter cable has a two pin connector on one end
and a terminal on the end of one green wire and two
spade lugs at the end of a varistor spliced to the
other green wire.
AK58-00263-0000 – Qty. 1 – Hi-Pot Jumper cable is a two pin connector with a
green wire looped between both pins.
AK65-00043-0001 – Qty. 1 – Cable from MIB in console to Activity Zone
AK65-00047-0000 – Qty. 1 – Heart Rate Ergo Bar cable
AK65-00051-0000 – Qty. 1 – 20” C-Safe cable. From splitter to console.
AK65-00051-0001 – Qty. 1 – 65” C-Safe upright cable. Runs from the base to the
splitter in the bridge assembly.
AK65-00073-0000 – Qty. 1 – Cable Assy: Power DSP (Dom. Low Voltage units only)
AK65-00073-0001 – Qty. 1 – Cable Assy: Power DSP; High Voltage (Domestic)
AK65-00073-0002 – Qty. 1 - Cable Assy: Power DSP; High Voltage (International)
AK65-00074-0000 – Qty. 1 – Home switch cable from home switch to Motor
Controller.
AK65-00081-0000 – Qty. 1 – AC power cable with an IEC connector on one end
and a ring terminal on the Green/Yellow wire and
spade lugs on the brown and blue wires.