Lindy 42856 - Manual (Page 16)

English Manual
5.9 MAC Driver Installation
Follow the steps below to install driver of USB-Serial adapter:
5.9.1 Power on your computer and make sure that the USB port is enabled and
working properly.
5.9.2 Insert the USB-Serial adapter software driver into the CD-ROM drive and
copy the “D:\Driver\USB-SERIAL ADAPTER\MAC\SETUP.SIT” to the
desktop from the CD-ROM.
5.9.3 Run the SETUP.SIT from the desktop, it will auto run the program and
create a PL-2303G on desktop.
5.9.4 Copy the “PL-2303G” to the “System Folder”-“Extensions”.
5.9.5 To make sure that your computer can use the device correctly, you have to
check the “Apple System Profiler”-“Device and Volumes”. It will show
the USB Device