Lenoxx Electronics CD-2086 - Manual (Page 13)

IB-CD2086(AD)-WM-E-031705
MP3 PROGRAMMED PLAY
During programming, the symbol “PROG” shows in the display. To program play in your
preferred order, follow steps below:
The tracks (songs) on the disc can be programmed (arranged in advance) to play in
any order you prefer (up to 20 tracks can be programmed).
NOTE:
1. Programming can only be done in STOP mode.
2. The programmed memory will be lost if the STOP button is pressed twice, or the
alkaline batteries are exhausted or removed, or AC power is shut off, or the CD
DOOR is opened.
3. The player will stop automatically after all programmed tracks have been played.
To cancel programmed play
Press the STOP button twice, the symbol PROG will disappear from the display.
To change the current program
Just create a new program following the programming procedure.
12
Programming Example
Program Number 1 2 3 4 5 6 7 8
etc.
etc.
etc. Track Number (song number) 3 5 8 1 2 4 1 1
Album Number (title number) 3 6 10 4 1 7 2 5
1. Slide the FUNCTION switch to the CD/
MP3 position. Make sure the set is in
STOP mode (the total album number and
track number show in the display).
2. Press the PROGRAM/EQ button, the
symbol “PROG” will show in the display
and the album number “
” will flash.
PROG
3. Press the SKIP/SEARCH ( or )
buttons to select the title number 3
(example).
PROG
PROG
5. Press the SKIP/SEARCH ( or )
or +10 button to select the track
number (example 1).
4. Press the PROGRAM/EQ button to
confirm. Title 3 is now selected, and
the display will show:
PROG
PROG
6. Press the PROGRAM/EQ button to
confirm. Track 1 is now programmed.
The program number 2 will show in
the display, r eady for the next
selection of track.
7. Repeat above steps 3 to 6, you can
program up to 20 tracks.
8. After programming is finished, press the
PLAY button to begin programmed play.
IB-CD2086-WM-E-012005(WMA).pmd 3/22/2005, 5:52 PM 13