Lenovo THINKSERVER 392 - Manual (Page 71)

Menu item Submenu item Selections Comments
• Power on
If the power is interrupted
when the server is on, after
the power resumes:
• If you have selected Stay
off, the server will stay in
the off state.
• If you have selected Last
State, the server will
resume to the last state.
• If you have selected
Power on, the server will
restart automatically.
SATA Mode • IDE Mode
• AHCI Mode
• RAID Mode
Select SATA controller
operation mode. If you
want to configure RAID,
choose RAID Mode for the
SATA controller.
SATA Port0 View the information about
the SATA device connected
to the SATA connector 0 on
the system board.
SATA Port1 View the information about
the SATA device connected
to the SATA connector 1 on
the system board.
SATA Port2 View the information about
the SATA device connected
to the SATA connector 2 on
the system board.
SATA Port3 View the information about
the SATA device connected
to the SATA connector 3 on
the system board.
SATA Port4 View the information about
the SATA device connected
to the SATA connector 4 on
the system board.
SATA Configuration
(set SATA configuration
parameters)
SATA Port5 View the information about
the SATA device connected
to the SATA connector 5 on
the system board.
Onboard Graphics
Controller • Disabled
• Enabled
Enable or disable
the onboard graphics
controller.
Primary Graphics • Onboard
• Add-On
Choose a mode for primary
graphics. The Add-On
option requires a graphics
card installed.
Onboard LAN1 I/O ROM • Disabled
• Enabled
Enable or disable the
onboard LAN1 I/O ROM.
PCI Configuration (set PCI
configuration parameters)
Chapter 5 . Configuring the server 59