Lucent Technologies GW-DS300N - Manual (Page 60)

4
56
GW-DS300N
2.Right click on the AP mode icon, and click “Launch Config Utilities”
to enter the AP mode configuration page. If you want to switch back
to the Station Mode, you may just click “Switch to Station Mode”.
Also you can click “Start ƖProgramsƖPlanex WirelessƖPLANEX
Wireless Utility” on the desktop to open the utility.
4.2 Con Àg
After switch GW-DS300N to the AP mode, users can set up the general
settings, encryption, authentication, and so on. If you want to check the
advanced setup and information, please refer to the following chapters.
If you want to configure the general settings, please refer to the following
instructions.
Items Descriptions
Please select the adapter which you’re using now
and then click “Enable ICS”.
The default AP name (SSID) is “SoftAP-XX” (XX
is the last 2 digits of the adapter’s MAC address).
Or you can choose “Use MAC Address” and the
system will automatically copy the NIC MAC
Address to this column and add two characters,“AP”,
before the MAC address.
Internet
Connection
Sharing with
SoftAP
SSID