Linksys DSSXFXST - Manual (Page 15)

Fiber Optic Modules
There are different 100BaseTX fiber add on modules available switches:
Modules with ST or SC-Type Fiber Optic Distance Extender Ports (can used on
the back of all the switches):
DSSXFXST ST-Type Single-Port Fiber Module
DSSXFXSC SC-Type Single-Port Fiber Module
The following chart shows the distance limitations when using any of the above
fiber modules:
Distance (m/ft) Cable Type Module in Switch A Module in Switch B
412/1330
Multi-Mode Any ST or SC-Type Any ST or SC-Type
(Half Duplex) 62.5/125uM 100BaseFX Fiber 100BaseFX Fiber
Fiber Optic Cable Optic Distance Extender Optic Distance Extender
2000/6560
Multi-Mode Any ST or SC-Type Any ST or SC-Type
(Full Duplex) 62.5/125uM 100BaseFX Fiber 100BaseFX Fiber
Fiber Optic Cable Optic Distance Extender Optic Distance Extender
When using fiber, noise loss must be accounted for. Noise loss means the
integrity of your data transfer over fiber optic lines, which occurs in fiber con-
nections, e.g. where the fiber is converted to copper lines in the switch, or
where the fiber cabling is not properly crimped on its connector tips. For
example, if your fiber cabling has ST connectors and you have an SC-type fiber
module, an SC to ST converter must be used. Otherwise, you can also replace
the ST connector with an SC connector.
If you have never worked with fiber cabling before, consult a networking pro-
fessional who is familiar with fiber cabling.
13
NOTE:
Changing connectors must be done professionally, and proper
tools must be used. If you have never worked with fiber cabling, con-
sult the help of a professional who is familiar with fiber.