Legacy Car Audio LCA Series - Manual (Page 3)

The supplied charging bulb(included
in the package)is used when initially
charging the Cap. the charging process
is accomplished by connecting the
charging bulb in series between the
battery
’s positive post and the
capacitor
’s positive terminal.(plese
refer to the diagram below). it is very
important to follow this process to
eliminate the possibility of damaging
the cap/battery, and other audio
devices. The charging process is
complete when the voltage of the
capacitor reaches the same voltage
as your vehicle
’s battery. This process
will take a matter of seconds to
complete. You can use a voltage meter
to check the voltage across your
battery and cup .when the voltages
are the same on both(cap and battery),
the cap has been fully charged. The
charging bulb actually eliminates the
need for the volt meter, when the cap
is fully charged (cap and battery have
same voltage) the bulb will go either
dim or fully out.
the capacitor must bi discharged
when the capacitor is removed form
the system. place the same bulb
which was used in charging across
the ter minals of the capacitor to
eliminate the stored power. The
capacitor will bi fully discharged
within a few seconds noted by the
1 year (except in the event the vent
is blown or leaking due to reversed
polarity or the cap has stripped
screws or terminals)
bul b going out. It is now safe to
store your a capacitor.
LCA-120DBL
LCA-240DBL
LCA-160SL
LCA-280SL
LCA-500SL
MODEL CAPACITANCE VOLTAGE DIMENSION
Dia. 3.0 x h. 8.86 1.2Farad 20~24V
Dia. 3.5 x h. 8.86 2.4Farad 20~24V
Dia. 3.0 x h. 8.86 1.6Farad 16~20V
Dia. 3.5 x h. 8.86 2.8Farad 16~20V
Dia. 3.5 x h. 8.86 5.0Farad 16~20V
PDF created with pdfFactory Pro trial version www.pdffactory.com