Linksys LKG0F755E User Manual

Page 3

11. Turn on the Network Storage Link by pressing its front panel button.

The Network Storage Link may take up to three minutes to completely power up.
During this time, the Ready/Status light will flash. When the Ready/Status light stops flashing
and remains solid green, the Network Storage Link is ready for use.

Note: For more information about the lights on the Network Storage Link, see Chapter 3:
“Connecting the Storage Link,” in the Linksys User Guide.

Installing the Linksys Software

12. Insert the Setup Wizard CD into your computer.

The Linksys Main Menu screen should appear after a few seconds.

Note: If the main menu does not appear, see Chapter 4: “Setting Up the Storage Link,” in the
Linksys User Guide.

13. Click Setup.

The Linksys software will search for the Network Storage Link connected to your network.

When your Network Storage Link is found, the message: “Network Storage Link(s) Have Been
Found!” will appear at the top of the screen and an icon and the name of your Storage Link will
appear in the Selection Column.

On the right side of the screen, you will see the IP Address of your Network Storage Link.

14. Write down this IP Address. You will need it later to use your networked OneTouch drive.

Note: If your Network Storage Link is not found, try clicking Search Again. If it is still not found,
see Appendix A: “Troubleshooting” in the Linksys User Guide.

Once your Storage Link is found, the next step is to format your OneTouch drive.

Keep the Linksys setup screen open and proceed to the next section.

Formatting the OneTouch Drive

15. On the left side of the Linksys setup
screen, double-click the icon for your Network
Storage Link.

Figure 4. Network Storage Link Icon

A web browser will open and the Home page for your Network Storage Link will appear.

Note: If your web browser does not automatically open, follow the steps in Chapter 6:
”Configuring the Storage Link,” in the Linksys User Guide.

Note: If you receive a “page cannot be displayed” message, you may need to change the IP
address (URL) of your Network Storage Link. See Chapter 4: “Setting Up the Storage Link,” in
the Linksys User Guide, for information about changing the Network Storage Link’s settings. If
you change the IP address of your Network Storage Link, be sure to write down the new number,