LG WM2688H*M - Manual (Page 15)

HOW TO USE THE WASHER
ENGLISH
1 5
■ SteamFresh TM cycle
• For slightly wrinkled clothes which have been stored
for an extended time. It makes wrinkled clothes
easier to iron (Do not load wet clothes).
• Wrinkles and odors will be reduced.
• To use the SteamFresh TM cycle :
1. Turn on the washer and select the SteamFresh TM cycle.
2. Load 5 items or less and close the door.
NOTE: Wipe the water off the drum.
3. Press the Steam button repeatedly until the
correct number of items is displayed.
4. Press the Start/Pause button.
• After the SteamFreshTM cycle is complete, the
drum will tumble for 30 minutes to prevent re-
wrinkling.
Press any button to unload the items. The Remote
Laundry Monitor (RLM) will display “End” for 2
minutes and then will display “---” for 28 minutes.
• After the SteamFreshTM cycle is complete, open
the door and allow it to cool down for best results.
Precautionary Notes:
- The SteamFresh
TM cycle is not like other washing or
drying cycles.
- Due to the characteristics of cotton fibers, this cycle is
not recommended for 100% cotton clothing.
- Remove stains from clothing before using the
SteamFresh TM cycle to prevent permanently setting the
stains by high heat.
- Be sure the faucet is open. This cycle uses a little water
to produce steam.
- Be careful not to touch the door. It can be very hot.
- Do not load the following items:
Wool, blankets, leather jackets, silk, wet clothes,
lingerie, foam products, or electric blankets.
- After removing clothes from the SteamFresh TM cycle
they may feel slightly damp. Wait at least 10 minutes
before putting the clothes on.
- Best results are achieved when articles are of similar
size and fabric type. Do not overload.
CAUTION:
- Do not reach into the washer while operating. Steam
can cause severe burns.
- Keep pets away from the washer.
• Press repeatedly to adjust the volume of the
Beeper.
9. Beeper
• Select a water temperature based on the type of
load you are washing.
• Follow the fabric care label and chart below for
best results.
• Warm rinses leave the loads dryer than cold
rinses. Warm rinses increase wrinkling.
• In cold climates, a warm rinse makes the load
more comfortable to handle.
• Cold rinses save energy.
• The Cold rinse temperatures depend on the cold
water at your faucet.
• This washer automatically adjusts the water level
for the type and size of wash load for best results.
It may seem there is no water inside the drum in
some cycles, but this is normal.
6. Wash/Rinse Temperature
• To change the spin speed, press the Spin Speed
button repeatedly to cycle through available
options.
• To start Drain/Spin cycle:
1. Press Power button to turn on.
2. Press Spin Speed button only.
3. Press Start/Pause button.
7. Spin speed
• To change the soil level, press the Soil Level
button repeatedly until the desired setting is on.
8. Soil Level
Suggested Wash Temp. Garment
Kitchen towels, sheets,
and baby garments
Whites and Heavy
soiled color-fast items
Most loads
Brightly colored items,
washable woolens
Extra Hot
Hot
Warm
Cold
!