Lumiscope 1134 - Manual (Page 7)

10 11 Installing the Batteries
1. To insert the batteries
A. Press down on the latch and lift the cover towards you
to open the battery compartment.
B. Insert 4 "AA" batteries as indicated. Make sure to match
polarities (+, –) on the batteries.
C. Replace the battery cover by inserting the two hooks at
the bottom into the slot, then push on the top area.
2. To Connect the AC/DC Adapter
A. Plug the AC/DC adapter (6V 500mA), into the jack
located at the bottom of this
unit. (shown in the diagram).
B. Use only the adapter
included with this unit.
1. Place your elbow on a table
so that the cuff is at the same
level as your heart. (Fig. A.)
Note: The level of your heart is
slightly below your armpit.
Relax your entire body,
especially the area between
your elbow and fingers.
2. If the cuff is not at the same
level as your heart or if
you can not keep your arm
completely still throughout the
reading, use a soft object such
as a folded towel to support
your arm. (Fig. B) Do not
allow hard objects to come in
contact with the wrist cuff.
3. Turn your palm upwards.
4. Sit upright in a chair, and take
5-6 deep breaths.
Avoid leaning back or
crossing your legs while the
measurement is being taken.
(Fig. C)
Fig. B
Correct Measuring Posture
Fig. C (
X
)
Fig. A
Note: Please remove
batteries when not in
use for an extended
period of time. Do not
dispose batteries with
household garbage.
Note: Remove batteries
when using the AC
adapter for an extended
period of time.