Lincoln Electric LINCOLN WELDING ARMS IM886 - Manual (Page 17)

C-1 ACCESSORIES C-1
OPTIONS AND ACCESSORIES
K1779-11 Mini Console
(See Firgure C.1)
The mini console adds more useful functions to the
welding arms. Included with the mini console are:
• 1/2" threaded female bulkhead fitting with 25ft. (7.6
m) of braided air hose for compressed air connec-
tions.
• Duplex receptacle with 25ft. (7.6 m) of 12/3 SJ cord
and male plug, rated for 15 amps.
• Panel mounted vacuum inlet connector (female) and
two flexible hoses.
• Welding gun hanger bracket.
• Mounting hardware.
The mini console bolts to the underside of the
Universal Wire Feeder bracket for quick installation.
MINI CONSOLE ASSEMBLY INSTRUCTIONS
(See Firgure C.2)
1. Assemble the vacuum inlet to the front of the Mini
Console Body using the M6 nuts and bolts provided.
2. Install the 1/4" short anchor couplers to the front of the
Mini Console Body.
3. Insert the 1/4" NPT male thread 3/8" hard hose connector
into the rear of the anchor coupler using teflon tape to
seal the threads.
4. Remove the rear lower knock out in the electrical box and
install the romex connector.
5. Insert the two 1/4"-20 x 1-1/2" carriage bolts into the two
holes at the front of the K1779-9 feeder support.
6. Mount the Mini Console Body to the bottom of the feeder
support and secure with nut and washer inside the con-
sole.
7. Feed the electrical cable and 3/8" braided air hose
through the 2" structural tube of the right side on the arm.
WELDING ARMS
FIGURE C.1