Land Rover Range Rover - Manual (Page 5)

9 8
Climate control and exterior lighting
Climate control
68 68
64 64
60 60
76 76
80 80
84 84
72 72 72 72 68 68
64 64
60 60
76 76
80 80
84 84
2 1 3 2
4
6
5
The following provides a brief overview of the basic functions of the climate control system.
4
1
2
3
5 6
Exterior lighting
1 . Exterior lamps off
2 . Side lamps
3 . Headlamps
4 . Autolamps
With the switch in Autolamps mode and the
engine running, a sensor monitors the
exterior light levels and will automatically
switch the side lamps and dipped
headlamps ON and OFF as required.
5 . Front fog lamps
6 . Rear fog lamps
3. Blower Control
Rotate clockwise to increase and anticlockwise
to decrease airflow from the vents.
4. Air distribution
More than one setting can be selected at once.
5. Heated rear screen
6. Heated front screen
Recommended mode
Select AUTO as the normal operating mode.
This will help prevent window misting.
1. AUTO (automatic) mode
Press to select automatic operation of the
climate control system. The system will
automatically adjust the heat output, blower
speed, air intake and airflow distribution so as
to maintain the selected temperature(s) and
reduce misting without constant adjustments
from the driver or passengers.
2. Temperature control
Rotate the controls to set the required
temperature for the corresponding side of the
passenger compartment.
External water deposits
The air conditioning system removes moisture
from the air and deposits the excess water
beneath the vehicle. Puddles may form but
this is normal and no cause for concern.
Climatic seats
Rotate to start the climatic seat function and to
adjust the temperature of the airflow.
Press once to ventilate the seat back only. Press
a second time to switch the climatic seat function
off. A third press will ventilate the seat back and
seat cushion.
Operating note
Climatic seats consume considerable power
from the battery. For this reason, they should
only be operated while the engine is running.
Direction indicators
Move the lever up or down to activate
the direction indicators.
Moving the lever up or down against spring
pressure and then releasing will flash the
indicators three times. Useful for lane
changing.
Headlamp high beam
Push the lever away from you to select
headlamp high beam. A warning
indicator will illuminate on the instrument
pack.
To flash headlamps, pull the lever part way
towards the steering wheel and release.