Life Fitness tr 8500 User Manual

Page 5

Step 1
Untie and uncoil the WIRE HARNESS attached to the
front, right side of the treadmill. Pull gently on the
HARNESS to remove any slack.

Step 2
Place the RIGHT HANDRAIL next to the treadmill and
feed the WIRE HARNESS CONNECTOR into the slot
located at the bottom of the RIGHT HANDRAIL (#10) until
it exits through the top opening.

Step 3
Position the RIGHT HANDRAIL (#10) in place on the treadmill
FRAME and align the mounting holes in the HANDRAIL with those in
the FRAME. Insert the two HANDRAIL BOLTS (#11) and WASHERS
(#12) through the HANDRAIL and into the FRAME to secure it.
Tighten these BOLTS until snug, then loosen both BOLTS two
complete revolutions counter-clockwise. Repeat this step for the
LEFT HANDRAIL (#9).

NOTE: The HANDRAIL BOLTS (#11) must be loose at this time to facilitate the assembly of the HANDLEBAR
ASSEMBLY (#5) and the CENTER SUPPORT (#2).

CAUTION! BE CAREFUL NOT TO PINCH WIRES BETWEEN THE RIGHT HANDRAIL AND THE UNIT FRAME.

REMARQUE! FAIRE ATTENTION DE NE PAS PINCER LES FILS LORSQU’ON ABAISSE LA MAIN COURANTE