Life Fitness 909101 ST - Manual (Page 13)

FIGURE 16
13
STEP 16:
• Screw the treaded end of the CABLE (23) approximately 3/4” into the end of the WEIGHT STACK SHAFT (19) and tighten jam
nut securely. See FIGURE 16.
• If the HEAD PLATE (20) does not sit on top of the first WEIGHT PLATE (54), push the head plate down, insert the SELEC-
TOR PIN (48) and perform several repetitions on the machine. This will relax the cable system and prevent the HEAD PLATE
(20) from lifting up.
• If after completing the previous step the HEAD PLATE (20) still does not sit on top of the first WEIGHT PLATE (54) or if there
is excess slack in the cable system, adjust the threaded end of the CABLE accordingly and retighten the jam nut.
• Loop the threaded end of the CABLE (23) throught the holes and around the pulleys in the TOWER BRACE (10) as shown in
FIGURE 16.
23
19
48
20
54
• Thread two 3/8 X 1” BOLTS (38) and two 3/8” WASHERS (41) one-quarter of the way in to the threaded holes on the TOWER
(1) as shown in FIGURE 16.
3/8 X 1” 38
41
1
10