Initial set-up, Example - failed auto set-up – Loewe Individual Sound Projector User Manual
Page 16

- 16
END
END
Sound components wizard
The auto setup is running. Please wait ...
During the measurement nobody should be present in the room.
After about 3 minutes a final chime is played. The procudure can be
cancelled by the key.
➠
Duringauto set-up, the listening room should be free of noise interference.
Please leave the room during this time so that the sound beams can spread
without disturbance.
➠
Ifan error occurs during auto set-up, a warning will sound and a message
will appear on the TV screen (page 6). If necessary, check the above described
conditions for the Sound Projector to work perfectly.
➠
Autoset-uptakes about 3 minutes and a final chime sounds when it
finishes.
➠
You can save three listening positions and call them up again, for example,
to be able to take changing conditions in the listening room into consideration.
➠
Position the microphone at least 1.8 m away from the Sound Projector centred
on it on a level surface.
After auto set-up has been completed, a message will appear
on the screen.
Example 1 - successful auto set-up:
END
OK
OK
Sound components wizard
With the key the position and the corresponding adjustments of the auto
setup are stored to "Position 1 (MEM1)".
Store settings
Sound projector
Sound components
Proceed
OK
Example - failed auto set-up:
END
OK
OK
Sound components wizard
Hint: The auto setup failed with Error E-1 (Too much noise).
Too much noise. Please restart the auto setup with the key.
Start auto setup
Sound projector
Proceed
OK
➠
If the message "Note: The auto set-up failed due to problem E-1 (room is too
noisy)" is displayed , repeat the auto set-up process . Please also read the "Error
messages for auto set-up" on page 6.
OK Apply results of auto set-up.
Remove the microphone from the Sound Projector now.
The Sound Projector is now ready.
You will find information on operating the Sound Projector
from page 19 onwards.
Initial set-up