Laser PW-AD90W - Manual (Page 3)

PW-AD90W User Manual
4 5
OPERATION INSTRUCTION FOR LAPTOP USE
1. Connect to general mains power outlet (picture A). As a default setting and
before any connectors are attached, the LCD screen will show a blue backlight
with default voltage settings (picture B) note: the screen may blink red on
startup.
2. Refer to the supplied information for the suitable laptop connector for your use.
a. Attach the connector.
b. At this stage the LCD backlight is still blue and will now refl ect the correct
voltage per your connector choice. (Picture C and D)
c. Insert connector into laptop device
OPERATION INSTRUCTION FOR USB USE
a. Simply connect to general mains power outlet.
b. Insert USB cable as pictured below (picture E)
Notice
Please always refer to the supplied laptop connector reference chart before use.
Check that the selected connector and voltage output against your existing power
supply. All liability for incorrect use and damage shall be born by the end user.
Caution
1. This device is for indoor use only. To promote effective use, always use in a well
ventilated area and avoid covering the unit while charging. Avoid use in high
temperatures and high moisture environments.
2. As with most power adaptors, this unit may become warm to touch during
operation.
3. To avoid component damage, please avoid dropping or otherwise treating the
unit roughly.
4. As a safety precaution this unit has no serviceable parts. Do not try to
disassemble or open this unit for any reason.
PW-AD90W_user_manual.indd 4-5 16/09/2009 12:09:18 PM