Starting and shutting down the projector, Starting, Shutting – Lenovo M500 User Manual
Page 27: Down, Projector
Starting
and
shutting
down
the
projector
1.
Connect
the
power
cord
to
the
projector.
Connect
the
other
end
to
a
wall
outlet.
This
turns
on
the
POWER
and
READY
LEDs
on
the
projector.
2.
Turn
on
the
connected
devices.
3.
Ensure
that
the
Ready
LED
is
on
a
steady
(not
flashing)
orange
and
then
press
the
Power
button
to
turn
on
the
projector.
The
projector
splash
screen
displays
and
connected
devices
are
detected.
If
the
connected
device
is
a
PC,
press
the
appropriate
keys
on
the
computer
keyboard
to
switch
the
display
output
to
the
projector.
(Check
the
user
manual
of
the
PC
to
determine
the
appropriate
Fn
key
combination
to
change
display
output).
See
″Navigating
the
OSD
on
if
Security
Lock
is
enabled.
4.
If
more
than
one
input
device
is
connected,
press
the
Source
button
repeatedly
to
switch
among
devices.
DVI
and
component
video
are
supported
through
the
DVI-I
connector.
5.
To
turn
off
the
projector,
press
the
Power
button.
The
projector
prepares
for
shutdown
and
a
″Wait
a
moment
please...
″
message
appears.
6.
When
the
″Power
Off?/Press
Power
again
″
message
appears,
press
the
Power
button.
The
projector
turns
off.
Note:
This
projector
has
a
fast
shutdown
cycle
to
let
you
unplug
the
projector.
However,
to
allow
proper
cooling
of
the
bulb,
the
projector
will
not
turn
on
again
for
60
seconds.
Attention:
Do
not
unplug
the
power
cord
until
the
Ready
LED
stops
flashing,
indicating
the
projector
has
cooled
down.
Chapter
2.
Setup
and
Operation
2-3