Liebherr 7082 - Manual (Page 10)

O
PERATION
6 BFI/BF1055 (7082 244-00)
* Depending on model and options
You can change the settings in increments by
briefly pressing the buttons again. If the buttons are
held down, the temperature setting will change
faster. Approximately five seconds after the button
has been released, the display will automatically
show the actual freezing or BioFresh temperature
(known as the “actual setting”).
The altered temperature will adjust slowly to the
new value.
Additional Features
In set-up mode you can set the Childproof Lock,
adjust the brightness of the display* and choose
the unit of temperature in degrees Fahrenheit or
degrees Celsius for the display.
To activate the set-up mode:
• Press SuperFrost button for approximately five
seconds, the SuperFrost will button will flash and
the display shows
for Childproof Lock.
Note
The value to be altered will flash.
• Select the required function by pressing the ?/?
(UP/DOWN) button:
= childproof lock or = brightness or
= unit of temperature.
• Now select/acknowledge function by pressing
the SuperFrost button briefly:
– For = childproof lock, press the
/ (UP/DOWN) button to select
= childproof lock ON or =
childproof lock OFF and acknowledge with
the SuperFrost button. When the symbol (6) is
lit, the childproof lock is activated.
– For = brightness, press /
(UP/DOWN) select = minimum to
= maximum brightness and
acknowledge with the SuperFrost button.
– For = unit of temperature, press
the / (UP/DOWN) button to select
° C = degrees Celsius or °F = degrees
Fahrenheit for temperature display
and acknowledge with the SuperFrost
button.
To exit set-up mode:
• Press the ON/OFF button; after two minutes the
electronic system automatically switches over
and the normal operating mode is activated.
Temperature Display
When the appliance is switched on (Fig. 1, 3), the
set unit of temperature °F or °C appears on the
display (Fig. 1, 7) for a few seconds.
If you wish to change the unit of temperature, you
can adapt the display.
Refer to Additional Functions, unit of
temperature for more information.
In normal operation, the following settings will be
displayed:
– the average BioFresh temperature in display
(Fig. 1, 7) and
– the warmest frozen food temperature in
display (Fig. 1, 1).
The display will flash:
– if you change the temperature or
– if the temperature rises by several degrees,
indicating a rise in temperature from placing
fresh, "warm" food in the freezer or if you remove
or re-pack frozen food, the temperature may rise
for a short time due to warm air flowing into the
freezer.
Once you have finished loading or re-packing, the
electronics will automatically re-set the temperature
to the most recent setting. Short-term rises in
temperature will not affect the frozen food.
• If F 0 to F 5 appears in the display, the appliance
has recognized a fault. Contact your Liebherr
retailer or the customer service department and
indicate the fault number displayed; this will tell
the technician what kind of irregularity has
occurred.
Audible Warning Signal - Figure 1
The audible warning signal helps to protect frozen
food and to save energy.
The audible warning device is turned off by
pressing the audible warning ON/OFF button
(Fig. 1, 5).
The alarm will turn off automatically as soon as the
temperature is low enough or the door is closed.
7082_244_00_Use Manual.qxd 10/21/2004 8:05 AM Page 6