LaCie Brick - Manual (Page 22)

LaCie Brick Hi-Speed USB 2.0
Desktop Hard Drive User’s Manual
5. Troubleshooting
In the event that your LaCie CD-RW Drive is not working correctly, please refer to the following checklist to find out where the
problem is coming from. If you have gone through all of the points on the checklist and your drive is still not working
correctly, please have a look at the FAQs that are regularly published on our Web site –
www.lacie.com . One of these
FAQs may provide an answer to your specific question. You can also visit the drivers pages, where the most recent software
updates will be available.
If you need further assistance, please contact your LaCie reseller or LaCie Technical Support (see 6. Contacting Customer
Service for details).
Manual Updates
LaCie is constantly striving to give you the most up-to-date, comprehensive User’s Manuals available on the market. It is our
goal to provide you with a friendly, easy-to-use format that will help you quickly install and utilize the many functions of your
new device.
If your manual does not reflect the configurations of the product that you purchased, please check our Web site for the most
current version available.
Troubleshooting
page 22
The Issue
The drive is not
recognized.
Questions to Ask
Is the drive’s power on?
Does an icon for the drive appear
on the computer?
Are all of the cables connected
securely and correctly?
Are both ends of the USB cable
connected and properly seated?
Possible Solutions
Check to see that all of the power cords are properly
connected and that the switch on the rear of the drive is
turned on. If you are using a surge protector, make sure that
it is switched on, too.
Check for an icon on the Desktop (on a Mac) or in My
Computer
(on a PC).
Make sure that all the steps in section 2. Getting Connected
have been followed correctly. Examine the connections
carefully to ensure that all the cables are inserted in the
correct orientation and in the correct location.
Check both ends of the USB cable. Disconnect them, wait 10
seconds, and reconnect them. If the drive is still not
recognized, restart your computer and try again.