Linksys WPG54G - Manual (Page 12)

6 Chapter 3: Getting to Know the Presentation Player
Overview
Wireless-G Presentation Player
Chapter 3: Getting to Know the Presentation Player
Overview
This chapter describes what is on the back and front panels of the Presentation Player, and the remote control.
The Back Panel
The Presentation Player's ports, where a network cable is connected, and the reset button are located on the
back panel. See Figure 3-1.
USB The USB port is where you will connect the USB memory disk device.
Monitor/Projector The Monitor/Projector port is where you will connect the VGA cable from the monitor or
projector where your presentation will be displayed.
LAN This LAN (Local Area Network) port connects to Ethernet network devices, such as a
switch or router.
Power The Power port is where you will connect the power adapter.
Reset Button There are two ways to reset the Presentation Player's factory defaults. Either press the
Reset Button, for approximately ten seconds, or restore the defaults from the
Administration tab in the Presentation Player's Web-based Utility.
With these, and many other, Linksys products, your networking options are limitless. Go to the Linksys website at
www.linksys.com for more information about products that work with the Presentation Player.
Important: Resetting the Presentation Player will erase
all of your settings (WEP Encryption, Wireless and LAN
settings, etc.) and replace them with the factory default
settings. Do not reset the Presentation Player if you want
to retain these settings.
Figure 3-1: Back Panel