Lenoxx Electronics CD-896 - Manual (Page 6)

IB-CD896(CDX85KR-60B3)-WM-E-070706 5
Remove two
large screws
with a dime or
screwdriver Move cord to
desired position
(three cord
positions)
The car cassette adaptor allows you to use your CD player with your car stereo
cassette system, this adaptor will pass the CD music through your car’s cassette
player and car stereo.
1. Insert the car cassette adaptor in the same
direction as you would insert an audio cassette
tape, with the side marked THIS SIDE UP facing
upwards.
2. If the car cassette adaptor cord is on the wrong
side of the tape, reposition the cord by following
the instructions below.
3. Insert the car cassette adaptor stereo plug into
the LINE OUT jack on the left side of the CD
player.
4. Turn on the cassette player. Press the PLAY
button on the cassette player.
5. Press the PLAY button on the CD player.
6. Adjust the VOLUME control on your cassette
player.
7. When done, leave the cassette player on and
first eject the adaptor, then turn off cassette
player.
Reposition the cord
The cord should extend out from the cassette
player when the cassette is inserted (direction
depending on your tape player).
1. To reposition the cord, remove the top plate by
removing 2 screws with a dime (see Fig. 1).
2. Reposition the cord so that it comes out from
other positions (see Fig. 2).
3. Replace the cover and the screws.
TO LINE OUT JACK
CASSETTE ADAPTOR
Fig. 1 Fig. 2
NOTE: The car cassette adaptor has the play head on one side only. If the cassette
adaptor keeps ejecting out, or the sound is weak, press the REVERSE button
on your cassette player to change direction or reverse the adaptor.
IB-CD896(CDX85KR-60B3)-WM-E-111605.pmd 7/7/2006, 12:26 PM 6