Life Fitness Adjustable Decline Bench - Manual (Page 7)

1. Slide one ROLLER PAD (1) onto one PAD SHAFT (A) until it contacts the
pre-installed SHAFT COLLAR (B). Secure the ROLLER PAD using one
FENDER WASHER (2) and one M10 X 25mm BOLT (3) as shown. Tighten
the BOLT securely. Insert one ROLLER PAD CAP (4) onto the ROLLER PAD
as shown.
Repeat this procedure to install the remaining ROLLER PADS onto the
remaining PAD SHAFTS.
2. Attach the HEAD PAD (5) and BACK PAD (6) to the BACK FRAME (7) using
five M10 X 35mm BOLTS (8) and five 3/8" SAE WASHERS (9). Tighten all
BOLTS securely.
3. Assemble the BASE SUPPORT FRAME (10) to the BASE FRAME (11) using
two M10 X 25mm BOLTS (3), four 3/8" SAE WASHERS (9) and two M10
NYLOCK NUTS (12) as shown. Tighten all BOLTS and NUTS securely.
4. Assemble the SEAT ADJUSTMENT ASSEMBLY (13) to the BASE FRAME
(11) using one PIVOT SHAFT (14). Secure the PIVOT SHAFT using two M10
X 25mm BOLTS (3) and two 3/8" SAE WASHERS (9) as shown. Tighten the
BOLTS securely.