Lumiscope 1100 - Manual (Page 7)

Recalling Memory
1. To recall stored blood pressure readings from memory,
simply press the Memory button. The last set of
memorized readings will be displayed.
2. Another press of the Memory button will recall the
previous set of readings.
3. All readings stored in memory will be displayed with its
sequence number.
7
Helpful Tips
Here are a few helpful tips to help you obtain more accurate readings:
• Do not measure your blood pressure immediately after consuming a large meal. To obtain
more accurate readings, please wait one hour before measuring.
• Do not smoke or drink alcohol before measuring your blood pressure.
• You should not be physically tired or exhausted while taking a measurement.
• It is important that you relax during measurement. Take a 15-minute rest before a reading.
• Do not take measurements if you are under stress or under tension.
• Take your blood pressure at normal body temperature. If you are feeling cold or hot, wait a
while before taking a measurement.
• If the monitor is stored at very low temperature (near freezing), have it placed at a warm
location for at least one hour before using it.
• Wait about 5 minutes before taking the next pressure measurement.
If any abnormality should arise during use, please check the following points:
Troubleshooting
Symptom
No display when the
POWER button is pressed
EE mark shown on display
or the blood pressure value
is displayed excessively
low (high)
Check Point
Have the batteries run down?
Have the batteries’ polarities been
positioned incorrectly?
Is the cuff placed correctly?
Is the cuff pressure pumped enough?
(50~60 mmHg above normal systolic
value?)
Did you talk or move during
measurement?
Did you shake the arm with the cuff on?
Correction
Replace with two new batteries
Re-insert the batteries in the correct
positions.
Wrap the cuff properly so that it is
positioned correctly.
Measure it again and pump up 50~60
mmHg more than normal systolic
value.
Measure it again quietly.