Lyngdorf Audio CD-1 - Manual (Page 19)

- 19 -
Technical specifications
All audio measurements, except frequency response, are measured with a 20KHz low-
pass filter in accordance with AES-17. Measured on Unbalanced outputs - RCA (phono).
Audio
Parameter Value Note
Frequency response L/R +/- 0.02 dB 20 – 20000 Hz
Signal-to-noise ratio -115 dBA (“infinity zero” track) A-wgt
Dynamic Range -100 dBA (output -60 dBFS 1kHz) A-wgt
Distortion: THD + N 0.0018 %
Crosstalk -114 dB 125 – 16000 Hz
0db analog output level 3.8 Vrms
Unbalanced analog output
impedance 75 Ohm
Balanced analog output
impedance 100 Ohm
3 digital outputs: AES, SPDIF Toslink
Selectable sample rates on
digital outputs: 44.1kHz – 16 bits
48 / 96 / 192 kHz – 24bits
Protection
Parameter Value Note
Grounding Mains earth, chassis and audio
ground are connected
internally.
Over temperature All heat sinks and mains-
transformer. Auto resetting thermal fuse in
mains transformer.
Mains
Parameter Value Note
Mains input connector IEC 320 cold type Mains lead supplied.
Mains voltage range 100-120V AC, 50–60Hz Mains selector on 115V
Mains voltage range 200-240V AC, 50-60Hz Mains selector on 230V
Internal mains fuse T1Ah
Power consumption 2.5W STANDBY mode.
Power consumption 20W OPERATE mode, Playing CD